we provide Verified Cisco ccnp switch 300 115 dumps sample question which are the best for clearing certprepare 300 115 test, and to get certified by Cisco SWITCH Implementing Cisco IP Switched Networks. The cisco 300 115 Questions & Answers covers all the knowledge points of the real examcollection 300 115 exam. Crack your Cisco ccnp routing and switching switch 300 115 official cert guide Exam with latest dumps, guaranteed!

P.S. Verified 300-115 lab are available on Google Drive, GET MORE: https://drive.google.com/open?id=1WzeEi-YMJ4-9dZHT1BGDd5p41JZ_7zCq


New Cisco 300-115 Exam Dumps Collection (Question 6 - Question 15)

Q1. Which of the following HSRP router states does an active router enter when it is preempted by a higher priority router? (Select the best answer.)

A. active

B. speak

C. learn

D. listen

E. init

F. standby

Answer: B


Q2. Refer to the exhibit.

Which two statement can be derived from the output of the show standby command? (Choose two.)

A. R2 Fai/O regains mastership when the link comes back up.

B. R2 becomes the active router after the hold time expires.

C. Router with IP 10.10 1 3 is active because it has a higher IP address.

D. If Fa0/0 is shut down, the HSRP priority on R2 becomes 80.

E. R2 is using the default HSRP hello and hold timers.

Answer: D,E


Q3. It a switch stack is configured to used SDM templates, where are the templates stored?

A. stack master

B. TFTP server

C. flash memory

D. all stack members

Answer: A


Q4. Refer to the exhibit.

(Picture was showing from CLI u201cshow spanning-tree vlan xxu201d that running on mode rapid-pvst).

If you have a new switch (that runs spanning-tree mode pvst+) connect to the exist switch, which statement is true?

A. It will not working between two switches

B. It will work, the new switch will communicate exist switch with PVST+

C. It will work, the new switch will communicate exist switch with Rapid-PVST

D. NA

Answer: B


Q5. Which two prerequisites for HSRP to become active on an interface are true? (Choose two.)

A. Cisco Express Forwarding must be disabled globally.

B. The VIP must be in the same subnet as the primary IP address.

C. A Virtual-MAC address must be configured on the interface.

D. An IP address must be configured on the interface.

E. PIM routing must be disabled on the interface.

Answer: B,D


Q6. Which command enables root guard on a Cisco switch at location id:28468780 ?

A. Switch (config)#spanning-tree guard root

B. Switch (config-if)#spanning-tree guard-root

C. Switch (config-if)#spanning-tree root guard

D. Switch (config-if)#spanning-tree guard root

E. Switch (config)#spanning-tree root guard

Answer: D


Q7. Which two statements about error-disabled ports are true? (Choose two.)

A. They can be recovered only by resetting the interface.

B. When a port is error-disabled, all traffic on the port stops.

C. When a port is error-disabled, it may continue to pass management traffic.

D. When a port is error-disabled, the port LED changes to solid orange.

E. By default, error-disabled ports automatically recover once the issue is resolved.

Answer: B,D

Explanation: When a port is in error-disabled state, it is effectively shut down and no traffic is sent or received on that port. The port LED is set to the orange color and, when you issue the show interfaces command, the port status shows as Errdisabled.


Q8. Which option is the minimum number of bindings that the DHCP snooping database can store?

A. 1000 bindings

B. 2000 bindings

C. 5000 bindings

D. 8000 bindings

Answer: D


Q9. Which two tasks must you perform to enable DHCP option 82 on an untrusted port? (Choose two)

A. Enter the ip dhcp snooping information option replace command to enable DHCP option 82.

B. Enter the ip dhcp snooping trust command to enable DHCP option 82.

C. Enter the ip dhcp snooping information option allow-untrusted command to enable the untrusted port.

D. Enter the ip dhcp snooping information option command to enable option 82.

E. Enter the ip dhcp snooping trust command to enable data insertion DHCP option 82.

Answer: C,D


Q10. Which virtual MAC address does HSRP group 37 use with default configuration?

A. C0.00:00:25:00:00

B. 00:00:0c:07:ac:25

C. C0:00:00:37:00:00

D. 00:00:00c:07:ac:37

Answer: D


P.S. Easily pass 300-115 Exam with 2passeasy Verified Dumps & pdf vce, Try Free: https://www.2passeasy.com/dumps/300-115/ (522 New Questions)