Our authorities create the actual Cisco Cisco certification online education course along with revise the planning materials with full devotion. Getting help from your Testkings Cisco exam dumps will cause you to get certified very easily. The on the internet Cisco 200-125 study guide is greater than the lengthy books for the 200-125 exam preparation. Youll be able to trust the actual success upon our Cisco Cisco exam question along with answers. Just spend a little money and a quick span of time on the Cisco 200-125 exam preparation.
2021 Sep 200-125 download
Q1. - (Topic 4)
What is the default administrative distance of OSPF?
A. 90
B. 100
C. 110
D. 120
Answer: C
Q2. - (Topic 9)
Which condition indicates that service password-encryption is enabled?
A. The local username password is encrypted in the configuration.
B. The enable secret is encrypted in the configuration.
C. The local username password is in clear text in the configuration.
D. The enable secret is in clear text in the configuration.
Answer: A
Q3. - (Topic 4)
Refer to the exhibit.
What can be determined about the router from the console output?
A. No configuration file was found in NVRAM.
B. No configuration file was found in flash.
C. No configuration file was found in the PCMCIA card.
D. Configuration file is normal and will load in 15 seconds.
Answer: A
Q4. - (Topic 2)
Refer to the exhibit.
A network administrator is configuring an EtherChannel between SW1 and SW2. The SW1 configuration is shown. What is the correct configuration for SW2?
A. interface FastEthernet 0/1
channel-group 1 mode active
switchport trunk encapsulation dot1q
switchport mode trunk
interface FastEthernet 0/2
channel-group 1 mode active
switchport trunk encapsulation dot1q
switchport mode trunk
B. interface FastEthernet 0/1
channel-group 2 mode auto
switchport trunk encapsulation dot1q
switchport mode trunk
interface FastEthernet 0/2
channel-group 2 mode auto
switchport trunk encapsulation dot1q
switchport mode trunk
C. interface FastEthernet 0/1
channel-group 1 mode desirable
switchport trunk encapsulation dot1q
switchport mode trunk
interface FastEthernet 0/2
channel-group 1 mode desirable
switchport trunk encapsulation dot1q
switchport mode trunk
D. interface FastEthernet 0/1
channel-group 1 mode passive
switchport trunk encapsulation dot1q
switchport mode trunk
interface FastEthernet 0/2
channel-group 1 mode passive
switchport trunk encapsulation dot1q
switchport mode trunk
Answer: C
Q5. - (Topic 9)
Which two commands can you enter to verify that a configured NetFlow data export is operational? (Choose two.)
A. show ip flow export
B. show ip cache flow
C. ip flow ingress
D. ip flow egress
E. interface ethernet 0/0
F. ip flow-export destination
Answer: A,B
Renew 200-125 test questions:
Q6. - (Topic 4)
Refer to the exhibit.
When running OSPF, what would cause router A not to form an adjacency with router B?
A. The loopback addresses are on different subnets.
B. The values of the dead timers on the routers are different.
C. Route summarization is enabled on both routers.
D. The process identifier on router A is different than the process identifier on router B.
Answer: B
Q7. - (Topic 9)
Which command can you enter to configure a local username with an encrypted password and EXEC mode user privileges?
A. Router(config)#username jdone privilege 1 password 7 08314D5D1A48
B. Router(config)#username jdone privilege 1 password 7 PASSWORD1
C. Router(config)#username jdone privilege 15 password 0 08314D5D1A48
D. Router(config)#username jdone privilege 15 password 0 PASSWORD1
Answer: A
Q8. - (Topic 9)
Which NAT function can map multiple inside addresses to a single outside address?
A. PAT
B. SFTP
C. RARP
D. ARP
E. TFTP
Answer: A
Q9. DRAG DROP - (Topic 1)
Answer:
Q10. - (Topic 9)
Which command can you execute to set the user inactivity timer to 10 seconds?
A. SW1(config-line)#exec-timeout 0 10
B. SW1(config-line)#exec-timeout 10
C. SW1(config-line)#absolute-timeout 0 10
D. SW1(config-line)#absolute-timeout 10
Answer: A