It is impossible to pass Cisco ccda 200 310 official cert guide pdf exam without any help in the short term. Come to Ucertify soon and find the most advanced, correct and guaranteed Cisco ccda 200 310 pdf practice questions. You will get a surprising result by our Updated Designing for Cisco Internetwork Solutions practice guides.
Q131. Which design is the recommended geometric design for routed topologies?
A. linear
B. triangular
C. rectangular
D. circular
Answer: B
Q132. What is the maximum RIPv2 hop count for a reachable route?
A. 13
B. 14
C. 15
D. 16
Answer: C
Q133. What two CoS values are used by voice traffic? (Choose two.)
A. COS1
B. COS2
C. COS3
D. COS4
E. COS5
Answer: C,E
Q134. You want to gather as much detail as possible during a network audit with a minimal impact on the network devices themselves. Which tool would you use to include data time stamping across a large number of interfaces while being customized according to each interface?
A. RMON
B. SNMPv3
C. NetFlow
D. Cisco Discovery Protocol
Answer: C
Q135. What is the first step when creating a network security policy?
A. define what should be protected
B. investigate how likely an attack is to occur
C. implement measures to protect assets
D. hire a security firm to perform penetration tests
Answer: A
Q136. What part of the network does a top-down network design focus on for solution development?
A. presentation
B. hardware
C. session
D. application
E. data link
F. transport
Answer: D
Q137. What is the most compact representation of the following IPv6 address?
2001:db8:0000:0000:cafe:0000:0000:1234
A. 2001:db8::cafe::1234
B. 2001:db8::cafe:0000:0000:1234
C. 2001:db8:0:0:cafe::1234
D. 2001:db8::cafe:0:1234
Answer: C
Q138. To provide Layer 2 connectivity between the primary and remote data centers, given that the two data centers are using Layer 3 routed DCIs, which NX-OS technology can be used to facilitate this requirement?
A. VRF
B. OTV
C. MPLS
D. SPT
E. VPC
Answer: B
Q139. Refer to the exhibit. On which router should you configure redistribution?
A. Router 1
B. Router 2
C. Router 3
D. Router 4
E. Router 5
Answer: B
Q140. A network engineer is using the traditional switched hierarchical design. The client has asked to increase uplink utilization from the access layer to the distribution. How can the engineer attain this new requirement without adding new physical connections?
A. enable spanning-tree portfast
B. enable VSS at the distribution layer
C. increase the MTU size on the uplink interfaces
D. ensure the root bridge priority is equal on both distribution switches
Answer: B