200-355 exam is also known as 200-355 which is the Cisco certification exam. Candidates can turn into a Cisco Cisco certified specialist by employing 200-355 training materials on Pass4sure site. Cisco Cisco is a world-widely recognized certification which is an essential passport in direction of IT sector. Succeeding in Cisco 200-355 exam could boost up your confidence along with increase your occupation value. Each of our IT professionals layout Cisco 200-355 exam dumps containing various logical questions along with verified answers in the means that could support you within cracking the Cisco 200-355 exam without any wearisome books or research materials. Pass4sure Cisco Cisco exam demos may become the beacon in your occupation because they comprise almost everything required to Cisco 200-355 genuine exam.

2021 Apr 200-355 exam answers

Q61. Refer to the exhibit. The site in this AirMagnet Survey heat map is ready for which level of service? 

A. data 

B. voice 

C. location 

D. RFID 

Answer: A 


Q62. Refer to the exhibit. A customer is using central web authentication with a Cisco 5508 Wireless Controller and Cisco Identity Services Engine. An error occurs when wireless clients are redirected to the hosted splash page. What is causing the client error? 

A. Secure Web Mode is disabled on the WLC. 

B. OCSP is disabled on the WLC. 

C. Management Via Dynamic Interface is disabled on the WLC. 

D. Ethernet Multicast Forwarding is enabled on the WLC. 

Answer: A 


Q63. Refer to the exhibit. 

A customer has enabled the primary DNS server to return the correct controller IP address in response to a CISCO-CAPWAP-CONTROLLER.localdomain request coming from new access points associating to the wireless network. The access points seem to still be receiving the wrong IP address and cannot associate to the primary controller. 

Why are the access points receiving the wrong IP information? 

A. The DHCP option 43 has an incorrect controller IP address configured. 

B. The DNS server must be configured to respond to CISCO-LWAPP-CONTROLLER.localdomain request. 

C. The controller and wireless action point need to be Layer 2 adjacent. 

D. The controller must be configured for DHCP option 15 request. 

Answer: A 


Q64. During an upgrade, the wireless infrastructure has seen a few access points join and then drop off the network. After further investigation, it appears the access points may have an IOS code version that is causing issues. Where in the controller is this information found? 

A. GUI > Wireless > Access Point > General 

B. CLI > show ap image all 

C. GUI > Monitor > Software Version 

D. CLI > show sysinfo 

Answer: A 


Q65. What is an MBSSID? 

A. a virtual AP configured on a physical AP that share a single physical device, which is one half-duplex radio 

B. a set of physical APs configured in a BSA to form cells that are controlled by a single controller 

C. the group of clients that are allowed to gain access to one or more SSIDs configured in an AP 

D. the identified overlap area between two cells, which identifies the clients that are operating in that area at any given time 

Answer: A 


Renovate 200-355 brain dumps:

Q66. The results of a Cisco WCS client troubleshooting tool are summarized into a simple visual representation of a four-part progression of the connection status for a wireless client. 

What are the four parts? (Choose four.) 

A. client MAC address 

B. 802.11 authentication 

C. IP address assignment 

D. 802.11 association 

E. successful association 

F. authentication method 

G. SSID 

H. client radio type 

Answer: B,C,D,E 


Q67. Old 2.4-GHz wireless laptops are unable to connect. What is the most likely cause of this problem? 

A. WLAN > General properties are incorrectly configured. 

B. WLAN > QoS properties are incorrectly configured. 

C. WLAN > Security properties are incorrectly configured. 

D. WLAN > Advanced properties are incorrectly configured. 

E. Wireless > AP > 802.11 b/g/n AP is incorrectly configured. 

F. Wireless > AP > 802.11 b/g/n > Network is incorrectly configured. 

Answer: F 


Q68. What is an interferer that an engineer may see in Cisco CleanAir? 

A. microwave ovens 

B. rogue APs 

C. malicious clients 

D. co-channel interference 

Answer: A 


Q69. Which single tool helps to troubleshoot client-related issues in a WLAN? 

A. The show and debug commands on the controller. 

B. The show commands on the AP. 

C. Client templates on the Cisco WCS. 

D. Client troubleshooting on the Cisco WCS. 

Answer: D 


Q70. What protocol is used to determine the best pathway back to a root access point? 

A. CCKM 

B. WNMP 

C. AWPP 

D. LWAP 

Answer: C