It is more faster and easier to pass the by using . Immediate access to the and find the same core area with professionally verified answers, then PASS your exam with a high score now.
Check 400-151 free dumps before getting the full version:
NEW QUESTION 1
DRAG DROP
Drag and drops the feature from the left onto the correct description on the right
Answer:
Explanation: 
NEW QUESTION 2
How is the virtual IP for an ACI VPC domain assigned?
- A. No virtual IP is available for VPC peers on ACI
- B. by DHCP using the default management network
- C. manually by the admin
- D. by DHCP using the infrastructure VLAN
Answer: A
NEW QUESTION 3
When deploying a sensor network that uses CoAP, which of the following must be done on thefirewall to allow sensor traffic into the data center?
- A. Enable NAT64
- B. Permit IP Option 135 traffic from the sensor IP address range(s)
- C. Permit UDP traffic from the sensor IP address range
- D. Configure stateful inspection for ROLL
Answer: C
NEW QUESTION 4
DRAG DROP
Drag and drop the best five fundamentals that have proven to enable real world loT successes in innovative companies from the left to the right (in no particular order). Not all options are used
Answer:
Explanation: Shift to Service Use the cloud Plan to Scale Automate
Follow Industry best practices
NEW QUESTION 5
An administrator is replacing a fabric interconnect.The failed interconnect was FI-A and was master at
the time of failure.Which process brings the replacement fabric interconnect into the cluster?
- A. Connect the new FI-A to FI-B USING THE Layer 1/Layer 2 cables onl
- B. Sync the configuration when prompted.Connect the management interface when the configuration is synced.
- C. Connect the new FI-A to the management network and the Layer 1/Layer 2 links to the existingFIB.Use the full state backup file to restore the configuration when prompted at the console.
- D. Connect the new FI-A to the management network onl
- E. Use the fuil state backup file to restore configuration through Cisco UCS Manager GUI.Connect the Layer 1/Layer 2 cables
- F. Connect the FI-A to the management network and the Layer 1/Layer 2 links to the existing FI
- G. Use the all configuration backup file to restore the configuration through Cisco UCS Manager GUI
- H. Connect the new FI-A to the management network and the Layer 1/Layer 2 links to the existing FI- B Let the system sync with FI-B when prompted at the console
Answer: C
NEW QUESTION 6
Which access policy determines whether or not interfaces will be members of the same virtual port channel in ACI environment?
- A. interface selector
- B. port channel
- C. port channel member
- D. policy group
Answer: A
NEW QUESTION 7
Refer to the exhibit.
Which two statements about this output are true? (Choose two)
- A. Ethanlyzer is a licensed feature
- B. Output indicate the traffic passing from one module to another (non-SUP)
- C. Ethanlyzer is available in all CISCO IOS/NX-OS/IOS-XR devices
- D. Outputs can be filtered using Wireshark filters
- E. Output are for all traffic going to the SUP
- F. Output shown are redirected to the logging flash
Answer: DE
NEW QUESTION 8
Which option lists valid configuration commands to help identify packet flows for ingress and egress
IP packets and provide statistics based on packet flows when configuring a Cisco Nexus Device via the CLI?
- A. NetFlow Record, NetFlow Exporter, NetFlow
- B. Flow Record, Flow Exporter, Flow Monitor
- C. IPFix Record, IPFix Exporter, IPFix Monitor
- D. sFlow Record, sFlow Exporter, sFlow
Answer: B
NEW QUESTION 9
Which two options are valid span configurations for a Cisco Nexus 1000 series Switch? (Choose2)
- A. N1000v(config)#monitor session 3N1000v(config-monitor)# source interface Ethernet 2/1-4 N1000v(config-monitor)# source interface vlan 3,6-8 tx N1000v(config-monitor)# filter vlan 3-5,7N1000v(config-monitor)# destinaiton interface Ethernet 2/2
- B. N1000v(config)#monitor session 3N1000v(config-monitor)# source interface Ethernet 3/1-3 N1000v(config-monitor)# source interface vlan 3,6-8 tx N1000v(config-monitor)# filter vlan 3-5,7N1000v(config-monitor)# destinaiton interface Ethernet 2/5
- C. N1000v(config)#monitor session 3N1000v(config-monitor)# source interface Ethernet 3/1 N1000v(config-monitor)# source interface vlan 3,6-8 tx N1000v(config-monitor)# filter vlan 3-5,7N1000v(config-monitor)# destinaiton interface Ethernet 3/2
- D. N1000v(config)#monitor session 3N1000v(config-monitor)# source interface Ethernet 2/1-3 N1000v(config-monitor)# source interface vlan 3,6-8 tx N1000v(config-monitor)# filter vlan 3-5,7N1000v(config-monitor)# destinaiton interface Ethernet 3/5
- E. N1000v(config)#monitor session 3N1000v(config-monitor)# source interface Ethernet 2/1-3 N1000v(config-monitor)# source interface vlan 3,6-8 tx N1000v(config-monitor)# filter vlan 3-5,7N1000v(config-monitor)# destinaiton interface Ethernet 2/5
Answer: CE
NEW QUESTION 10
Which sequence of QoS actions is taken on egress traffic on the Cisco Nexus 7000 Series Switches?
- A. queuing and scheduling, classification, marking, policing, mutation
- B. marking, policing, mutation, classification, queuing and scheduling
- C. classification, marking, policing, queuing and scheduling, mutation
- D. classification, marking, policing, mutation, queuing and scheduling
Answer: D
NEW QUESTION 11
Refer to the exhibit.
On which VLAN does VLAN Discovery occur?
- A. VLAN 200
- B. VLAN 1105
- C. VLAN 105
- D. VLAN 1
Answer: D
NEW QUESTION 12
Which three statements are considered best practice when configuring an NFS appliance port on
Cisco UCS? (Choose three)
- A. If storage and servers are located in the same subnets, then the appliance port VLANs should be allowed on the upstream switch
- B. Cisco UCS supports Static and Link Aggregation Control Protocol port channels for appliance port configuratio
- C. However, no virtual port-channel support
- D. If storage must be accessed outside of the Cisco UCS domain, then the appliance port VLANsshould be allowed on the upstream switch
- E. Use of the same VLAN for multiple storage protocol traffic is highly recommended to conserve VLAN namespace use
- F. If storage is configured in active/passive mode and both fabric interconnects require communication to the same controller, then the appliance port VLANs should be allowed on the upstream switch
- G. Configuration of the VLAN tagging on the storage side and on the Cisco UCS side simultaneously is recommended
Answer: BCE
NEW QUESTION 13
Refer to the exhibit.
Your application has a reduced health score.Upon inspection, you find a fault that impacts the health
score. The fault currently is in the soaking lifecycle stare. Which two options are possible next steps while in this state? (Choose two)
- A. Acknowledge the fault, which immediately clears it from the system
- B. Once the soaking timer expires the fault ceases and no change is expected in sevenitylevel.
- C. The condition ceases by itself and goes into the soaking-clearing state
- D. The condition ceases by itself and automatically clears the fault
- E. The soaking timer expires and moves to the Raised sevenitylevel
Answer: CE
NEW QUESTION 14
Which option lists key Cisco TrustSec architecture components?
- A. permit,deny,log
- B. classify,mark,deny
- C. authentication,authorization,access control
- D. identity,enforcement,authentication
Answer: C
NEW QUESTION 15
What is the correct location where the DPDK libraries run?
- A. User space
- B. Network Space
- C. Kernel Space
- D. Disk Space
Answer: A
NEW QUESTION 16
Which two connectivity modes does Cisco RISE support? (Choose 2)
- A. Directly connecte
- B. No virtual port channel is supported.
- C. Indirectly connecte
- D. Only Layer 3 adjacent.
- E. Indirectly connecte
- F. Only Layer 2 adjacent
- G. Indirectly connecte
- H. Layer 2 and Layer 3 adjacent.
- I. Directly connecte
- J. Virtual port channel is supported.
Answer: CE
NEW QUESTION 17
DRAG DROP
Drag and drop the VTP mode from left onto the correct description on the right.
Answer:
Explanation: Transparent – relays all VTP protocol packets that it receives o trunk port to all other trunk ports
dServer – creates, removes and modifies VLANs over the entire network
Client – cannot create, change or delete VLANs
Off – Does not forward any VTP packets
NEW QUESTION 18
Which option lists the cloud deployment model types?
- A. hybrid,community,mobile,and service
- B. public,private,mobile,and community
- C. public,private,hybrid,and community
- D. hybrid,public,shared,and mobile
Answer: C
NEW QUESTION 19
Which two guidelines and limitations of policy-based routing are true? (Choose two.)
- A. A match command can refer to more than one ACL in a route map used for policy-basedroyting.
- B. An ACL used in a policy-based routing route map cannot include a deny statement.
- C. The same route can be shared among different interfaces for policy-based routing as long asthe interfaces belong to the same VRF instance
- D. A policy-based routing route map can have multiple match or set statements per route- mapstatement
- E. Policy-based routing and WCCPv2 are not supported on the same interface if bank chaining isdisabled
Answer: BC
P.S. Certleader now are offering 100% pass ensure 400-151 dumps! All 400-151 exam questions have been updated with correct answers: https://www.certleader.com/400-151-dumps.html (276 New Questions)