Ucertify always provides the most correct and official Juniper Juniper exam dumps. Our own professionals are devoted to providing you with the higher technical exam questions and answers. They have rich knowledge in compiling your Juniper Juniper JN0-692 exam demos. Your good results and satisfaction is our primary goal.
2021 Nov JN0-692 exam guide
Q61. Click the Exhibit button.
You work for ISP A, as shown in the exhibit, and must configure R1 to use load balancing across both available links to ISP B's network. Which command do you use to finish the configuration?
A. set protocols bgp group isp-b multipath
B. set routing-options forwarding-table export per-packet
C. set protocols bgp group isp-b multihop
D. set routing-options forwarding-table load-balance
Answer: A
Q62. In the exhibit, NG-MVPN is used for a Layer 3 VPN. Which two statements are valid? (Choose two.)
A. The egress PEs for I-PMSI tunnels should signal a label value of 3.
B. The vrf-table-label parameter is configured on the PEs.
C. PIM must be enabled on the PE and P routers.
D. The provider tunnel shown is similar to a draft-Rosen default MDT.
Answer: B, D
Q63. What does the Junos command advertise-inactive allow?
A. OSPF inactive routes to be advertised using BGP
B. inactive and hidden BGP routes to be redistributed into OSPF
C. the best BGP route to be re-advertised by BGP, even when it is not the best route
D. the second-best BGP route to be re-advertised by BGP, to back up the best BGP route
Answer: C
Q64. You are a network administrator in charge of configuring CoS for your network. Your network includes a voice application with strict latency requirements, so that any packets delayed by more than 75 ms are effectively useless. When configuring the scheduler for this application, which feature ensures that you do not waste buffer space?
A. rate-limit
B. adaptive
C. latency-limit
D. temporal
Answer: D
Q65. You have been asked to make a configuration which inherits the statements in a predefined configuration group. What will accomplish this?
A. Option A
B. Option B
C. Option C
D. Option D
Answer: B
Up to the immediate present JN0-692 rapidshare:
Q66. An IS-IS level 1-only router is configured within a larger multilevel hierarchy. Which OSPF area type resembles the routing information in the L1 router's table?
A. OSPF default area
B. OSPF stub area
C. OSPF NSSA
D. OSPF NSSA with no summaries
Answer: D
Q67. Click the Exhibit button.
Using the configuration and topology in the exhibit, which statement is true?
A. Each LSR randomly selects the physical path to reach the loose hop R5 for the LSP.
B. Each LSR uses the IGP to select the physical path to reach the loose hop on R5 for the LSP.
C. Each LSR selects the lowest next-hop IP address to reach the loose hop on R5 for the LSP.
D. Each LSR selects the highest next-hop IP address to reach the loose hop on R5 for the LSP.
Answer: B
Q68. You have recently added LDP-signaled VPLS to your network. The VPLS connections are established and you have been asked to verify that the forwarding plane is working properly. Which three commands would you use? (Choose three.)
A. ping mpls Idp <fec>
B. show vpls connections
C. traceroute mpls Idp <fec>
D. show vpls mac-table
E. show Idp statistics
Answer: A, C, D
Q69. On your MX Series router, traffic using the less-critical scheduler is out of profile. All other data is currently in profile. Referring to the exhibit, which statement is correct?
A. The less-critical queue can use the remaining bandwidth.
B. The less-critical queue cannot buffer traffic, so traffic is dropped.
C. The less-critical queue is serviced before the critical queue.
D. The less-critical queue cannot use the remaining bandwidth.
Answer: A
Q70. Click the Exhibit button.
The output in the exhibit was captured on an interface. Which three statements are true about the configuration on the router with hostname SaoPaulo? (Choose three.)
A. Wide metrics is not in use.
B. The router has the overload bit set to "on".
C. Authentication is enabled.
D. System ID is 1921.6805.2001.
E. Level 2 routing is enabled.
Answer: A, C, E