Cause all that matters here is passing exam with N10-007 Dumps. Cause all that you need is a high score of N10-007 Study Guides. The only one thing you need to do is downloading N10-007 Dumps free now. We will not let you down with our money-back guarantee.

Online N10-007 free questions and answers of New Version:

NEW QUESTION 1
A company is allowing its employees to use their personal computers, tables, and loT devices while at work. However, there are rules and guidelines to which employees must adhere. Which of the following documents applies to these employees?

  • A. NDA
  • B. SOP
  • C. BYOD
  • D. SLA

Answer: C

NEW QUESTION 2
A network technician is implementing a solution on the network to hide the workstation internal IP addresses across a WAN. Which of the following is the technician configuring?

  • A. QoS
  • B. DMZ
  • C. RIP
  • D. NAT

Answer: D

NEW QUESTION 3
A technician looks at an ARP table in an attempt to resolve a connectivity issue. After table of the switch is a cleared, a different MAC in the output, Which of the following does this indicate?

  • A. ARP flooding
  • B. VLAN mismatch
  • C. Duplicate IP address
  • D. Faulty NIC

Answer: A

NEW QUESTION 4
Zach, a technician, is installing an 802.11n network. Which of the following should he disable to stop broadcasting the network name?

  • A. Channel
  • B. WEP
  • C. SSID
  • D. WPA

Answer: C

NEW QUESTION 5
A building is equipped with light sensors that turn off the fluorescent lights when natural light is above a certain brightness. Users report experiencing network connection issues only during certain hours. The west side of the building experiences connectivity issues in the morning hours and the east side near the end of the day. At night the connectivity issues affect the entire building. Which of the following could be the cause of the connectivity issues?

  • A. Light sensors are interfering with the network
  • B. EMI from the lights is interfering with the network cables
  • C. Network wiring is run perpendicular to electrical conduit
  • D. Temperature changes are causing attenuation in copper cabling

Answer: C

NEW QUESTION 6
A company has a large number of employees that need VPN access from home. Which of the following is the BEST solution for deploying and managing the remote access?

  • A. Site-to-site VPN
  • B. Network-based firewall
  • C. SSL VPN
  • D. Host-based firewall

Answer: C

NEW QUESTION 7
A network technician has to integrate three legacy industrial devices into the existing wireless network. The devices only support 802.11b and TKIP. Which of the following should the technician do to connect these devices to the wireless network with the restrictive settings while not affecting the performance of the other users? (Select Two).

  • A. Create a second SSID that uses WPA personal.
  • B. Change the encryption to WPA@ personal.
  • C. Enable MAC filtering.
  • D. Change the encryption to WPA2 Enterprise.

Answer: D

NEW QUESTION 8
A technician needs to order cable that meets 10GBaseT and safety requirements for an installation between a drop ceiling and a standard ceiling.
Which of the following should the technician order to ensure compliance with the requirements?

  • A. PVC Cat 5
  • B. Plenum Cat 5e
  • C. Plenum Cat 6a
  • D. PVC Cat 7

Answer: C

Explanation: 10GBaseT A 10 GbE standard designed to run on Cat 6a UTP cabling. Maximum cable length of 100 m.

NEW QUESTION 9
A technician is performing a maintenance task on a weekly basis and wants to ensure the task is properly documented and able to be performed by other technician. Which of the following types of documentation should the technician complete?

  • A. Standard operating procedure
  • B. Work order
  • C. Performance baseline
  • D. Logical diagram
  • E. Change management

Answer: A

NEW QUESTION 10
AContent filter is set to analyze XML and JSON that users access from the internet. At which of the following layer’s is this analysis taking place?

  • A. 1
  • B. 3
  • C. 5
  • D. 7
  • E. 6

Answer: E

NEW QUESTION 11
An 801.11g wireless access point was configured as follows:
- AP encryption forced to WPA2-AES mode only
- MAC address filtering enabled with the following MAC address in the allow list: 00-ab-29-da-c3-40 Which is true about the above configuration?

  • A. Any 802.11b/g compatible client can connect to the wireless network if they support TKIP, the MAC address is 00-ab-29-da-c3-40, and the encryption key is known by the client.
  • B. An 802.11a compatible client can connect to the wireless network only if its MAC address is 00- ab-29-da-c3-40 and the encryption key is known by the client.
  • C. An 802.11n compatible client can connect to the wireless network only if its MAC address is 00- ab-29-da-c3-40 and the encryption key is known by the client.
  • D. Any 802.11g compatible client can connect to the wireless network if the encryption key is known by the client.

Answer: C

NEW QUESTION 12
In a service provider network, a company has an existing IP address scheme. Company A’s network currently uses the following scheme:
N10-007 dumps exhibit
Company b uses the following scheme: Subnet 1: 192.168.1.50/28
The network administrator cannot force the customer to update its IP scheme. Considering this, which of the following is the BEST way for the company to connect these networks?

  • A. DMZ
  • B. PAT
  • C. NAT
  • D. VLAN

Answer: C

NEW QUESTION 13
Which of the following BEST describes the difference between layer 2 switching and layer 2 routing?

  • A. Switching moves packets between hosts on different subnets, and routing moves packets between hosts on the same subnet.
  • B. Routing moves packets between hosts on different subnets, and switching moves packets between hosts on the same subnet.
  • C. Both routing and switching move packets between hosts on the same subnet, but routing does so at a faster pace.
  • D. Both routing and switching move packets between hosts on different subnets, but switching does so at a faster pace.

Answer: B

NEW QUESTION 14
A technician has replaced the Internet gateway router, and now no users can reach the Internet. The technician can ping the router Ethernet port but not the ISP's router IP address. Which of the following is the MOST likely problem?

  • A. Faulty crossover cable
  • B. DNS server is down
  • C. Switching loop
  • D. Outside interface shutdown

Answer: D

NEW QUESTION 15
A network technician receives a spool of Cat 6a cable and is asked to build several cables for a new set of Ethernet runs between devices. Which of the following tools are MOST likely needed to complete the task? (Choose three.)

  • A. Wire stripper
  • B. Cable crimper
  • C. RJ-11 connectors
  • D. RJ-45 connectors
  • E. Multimeter
  • F. Punchdown tool
  • G. Tone generator

Answer: ABD

NEW QUESTION 16
Which of the following connector types would Sandy, a network technician, use to connect a serial cable?

  • A. RJ-11
  • B. BNC
  • C. LC
  • D. DB-9

Answer: D

NEW QUESTION 17
Which of the following protocols is associated with a three-way handshake?

  • A. UDP
  • B. ICMP
  • C. GRE
  • D. TCP

Answer: D

P.S. 2passeasy now are offering 100% pass ensure N10-007 dumps! All N10-007 exam questions have been updated with correct answers: https://www.2passeasy.com/dumps/N10-007/ (532 New Questions)