Q31. - (Topic 10)
How do you configure a FortiGate to apply traffic shaping to P2P traffic, such as BitTorrent?
A. Apply a traffic shaper to a BitTorrent entry in an application control list, which is then applied to a firewall policy.
B. Enable the shape option in a firewall policy with service set to BitTorrent.
C. Define a DLP rule to match against BitTorrent traffic and include the rule in a DLP sensor with traffic shaping enabled.
D. Apply a traffic shaper to a protocol options profile.
Answer: A
Q32. - (Topic 20)
Examine the following output from the diagnose sys session list command:
session info: proto=6 proto_state=65 duration=3 expire=9 timeout=3600 flags=00000000 sockflag=00000000 sockport=443 av_idx=9 use=5 origin-shaper=guarantee-100kbps prio=2 guarantee 12800Bps max 134217728Bps traffic
13895Bps
reply-shaper=guarantee-100kbps prio=2 guarantee 12800Bps max 134217728Bps traffic
13895Bps
state=redir local may_dirty ndr npu nlb os rs
statistic(bytes/packets/allow_err): org=864/8/1 reply=2384/7/1 tuples=3
orgin->sink: org pre->post, reply pre->post dev=7->6/6->7 gwy=172.17.87.3/10.1.10.1
hook=post dir=org act=snat 192.168.1.110:57999->74.201.86.29:443(172.17.87.16:57999)
hook=pre dir=reply act=dnat 74.201.86.29:443-
>172.17.87.16:57999(192.168.1.110:57999)
hook=post dir=reply act=noop 74.201.86.29:443->192.168.1.110:57999(0.0.0.0:0)
misc=0 policy_id=1 id_policy_id=0 auth_info=0 chk_client_info=0 vd=0
npu info: flag=0x00/0x00, offload=0/0, ips_offload=0/0, epid=0/0, ipid=0/0, vlan=0/0
Which statements are true regarding the session above? (Choose two.)
A. Session Time-To-Live (TTL) was configured to 9 seconds.
B. FortiGate is doing NAT of both the source and destination IP addresses on all packets coming from the 192.168.1.110 address.
C. The IP address 192.168.1.110 is being translated to 172.17.87.16.
D. The FortiGate is not translating the TCP port numbers of the packets in this session.
Answer: C,D
Q33. - (Topic 2)
What is the maximum number of FortiAnalyzer/FortiManager devices a FortiGate unit can be configured to send logs to?
A. 1
B. 2
C. 3
D. 4
Answer: C
Q34. - (Topic 15)
Which statements are correct properties of a partial mesh VPN deployment. (Choose two.)
A. VPN tunnels interconnect between every single location.
B. VPN tunnels are not configured between every single location.
C. Some locations are reached via a hub location.
D. There are no hub locations in a partial mesh.
Answer: B,C
Q35. - (Topic 7)
A FortiGate is configured to receive push updates from the FortiGuard Distribution Network, however, updates are not being received.
Which are two reasons for this problem? (Choose two.)
A. The FortiGate is connected to multiple ISPs.
B. There is a NAT device between the FortiGate and the FortiGuard Distribution Network.
C. The FortiGate is in Transparent mode.
D. The external facing interface of the FortiGate is configured to get the IP address from a DHCP server.
Answer: B,D
Q36. - (Topic 9)
Which web filtering inspection mode inspects DNS traffic?
A. DNS-based.
B. FQDN-based.
C. Flow-based.
D. URL-based.
Answer: A
Q37. - (Topic 1)
Which network protocols are supported for administrative access to a FortiGate unit? (Choose three.)
A. SNMP
B. WINS
C. HTTP
D. Telnet
E. SSH
Answer: C,D,E
Q38. - (Topic 6)
Which IPsec configuration mode can be used for implementing GRE-over-IPsec VPNs?.
A. Policy-based only.
B. Route-based only.
C. Either policy-based or route-based VPN.
D. GRE-based only.
Answer: B
Q39. - (Topic 7)
Which antivirus and attack definition update options are supported by FortiGate units? (Choose two.)
A. Manual update by downloading the signatures from the support site.
B. Pull updates from the FortiGate.
C. Push updates from a FortiAnalyzer.
D. execute fortiguard-AV-AS command from the CLI.
Answer: A,B
Q40. - (Topic 1)
What are valid options for handling DNS requests sent directly to a FortiGates interface IP? (Choose three.)
A. Conditional-forward.
B. Forward-only.
C. Non-recursive.
D. Iterative.
E. Recursive.
Answer: B,C,E