It is more faster and easier to pass the Cisco ccda 200 310 pdf exam by using Exact Cisco Designing for Cisco Internetwork Solutions questuins and answers. Immediate access to the Abreast of the times 200 310 pdf Exam and find the same core area 200 310 pdf questions with professionally verified answers, then PASS your exam with a high score now.
Q61. Multicast has been enabled and configured in the Enterprise, and PIM Sparse-mode has been enabled on all VLANs. What feature is required to stop multicast traffic from being broadcasted on the access layer switches?
A. IGMP snooping
B. Multicast boundary filter
C. PIM dense-mode
D. Dynamic ARP inspection
Answer: A
Q62. A wireless LAN client is sending traffic to the wired LAN client. What path will the packet take to reach the destination endpoint in a lightweight wireless deployment?
A. switch > controller > ap > client
B. controller > ap > switch > client
C. ap > controller > switch > client
D. switch > ap > controller > client
Answer: C
Q63. A circuit order has been placed for Gigabit Ethernet and is 80KM from the carrier equipment. What type of SFP will be required?
A. TX
B. SX
C. ZX
D. LX
Answer: C
Q64. Refer to the exhibit.
Which statement is true concerning enterprise edge distribution switches?
A. The speed of switching is the most critical feature.
B. Security requirements are offloaded to the other modules for performance reasons.
C. Edge distribution switches are only required when using a collapsed core backbone.
D. Enterprise edge distribution switches are similar to the building distribution layer.
Answer: D
Q65. Which two link state routing protocols support IPv6 routing? (Choose two.)
A. BGP4+
B. OSPF
C. RIPng
D. EIGRP
E. IS-IS
Answer: B,E
Q66. Your supervisor has asked you to deploy a routing protocol within the lab environment that will allow for unequal cost multipath routing. Which should you choose?
A. EIGRP
B. OSPF
C. IS-IS
D. RIP
Answer: A
Q67. Which network virtualization technology involves creating virtual routers with its own individual routing tables on a physical router?
A. VSS
B. vPC
C. VRF
D. VLAN
Answer: C
Q68. Which one of these statements describes why, from a design perspective, a managed VPN approach for enterprise teleworkers is most effective?
A. A managed VPN solution uses a cost-effective, on-demand VPN tunnel back to the enterprise.
B. This solution supports all teleworkers who do not require voice or video.
C. This architecture provides centralized management where the enterprise can apply security policies and push configurations.
D. It provides complete flexibility for remote access through a wireless hotspot or a guest network at a hotel, in addition to a home office.
Answer: C
Q69. A company has dark fiber between headquarters and its data center. It is presently configured as a 10GbE connection. Network utilization shows high utilization on the connection. What technology can be implemented to increase capacity without acquiring another circuit?
A. MPLS
B. DWDM
C. VPLS
D. DMVPN
Answer: B
Q70. What two features are advantages of adding a secondary WAN link at the enterprise edge? (Choose two.)
A. provides additional bandwidth and load balancing capabilities
B. acts as a backup link in event the primary link fails
C. reduces capital and operational costs
D. improves security and prevents against denial of service attacks
E. distributes traffic proactively based on link utilization
Answer: A,B