Q31. Refer to the exhibit. 

A network engineer configures a Cisco Unified Communications Manager and VCS integration via a SIP trunk. Endpoint A is able to conduct video calls to Endpoint B. When Endpoint A attempts to share presentation content with Endpoint B, Endpoint B sees the presentation video on the main screen rather than on the presentation display. What is the cause? 

A. The default MTP telephony payload is incorrect. 

B. The SIP trunk is not running on all active Cisco Unified Communications Manager nodes. 

C. MTP is not forced to be required. 

D. BFCP is not enabled. 

E. The MTP preferred codec is incorrect for content presentation. 

Answer: D 


Q32. Which three items should be considered when restoring a backup to a Cisco VCS Expressway? (Choose three.) 

A. A restart is required to complete the system restore process. 

B. If the backup file is encrypted, an encryption password will be needed. 

C. A valid backup configuration file must be accessible. 

D. A function SFTP server is needed for remote restore. 

E. The VCS expressway must be put into maintenance mode during the upgrade. 

F. A flash drive that is connected to the appliance can be used to restore the configuration. 

G. Cisco TMSXE can be used to process and restore backups. 

Answer: A,B,C 


Q33. Which CLI command can be used to reset the Cisco TelePresence System 500-32 personal video system to a factory condition? 

A. utils factory reset 2 

B. utils system factory init 

C. xcommand defaultvalues set level: 2 

D. xconfiguration default factory 

E. utils reset factory 

F. xcommand SystemUnit FactoryReset 

Answer: B 


Q34. In this item, you will need to use all information presented to you to successfully answer the question. 

The Cisco Telepresence Codec C90 is unable to call the Cisco IP Video Phone. Assuming that the calling search space has been configured correctly, which of the these can cause this issue? 

A. The Cisco Telepresence Codec C90 can only be registered to a Cisco Telepresence Video Communication Server. 

B. A multipoint control unit is required in order for the call to work. 

C. The Cisco Telepresence Codec C90 can only be registered as a SIP endpoint to Cisco Unified Communications Manager. H.323 is not supported. 

D. URI dialing has not been configured on Cisco Unified Communications Manager. 

E. The Cisco Telepresence Codec C90 Profile 1 > CallSetupMode must be configured as a gateway since Cisco Unified Communications Manager does not have a gatekeeper functionality. 

F. The Cisco Telepresence Codec C90 is not registered as a SIP endpoint on Cisco Unified Communications Manager. The Cisco Telepresence Codec C90 needs to be registered as both SIP and H.323. 

Answer: E 


Q35. A desktop video endpoint is needed that can support a PrecisionHD camera design and a built-in display, and is Bluetooth-ready and multisite-capable. Which desktop endpoint supports all of these requirements? 

A. SX20 

B. EX60 

C. SX80 

D. EX90 

Answer: D 


Q36. Which codec is most suitable for a video streaming solution? 

A. AAC-LD 

B. G.729 

C. H.264 

D. G.711 

Answer: C 


Q37. A network engineer wants to perform a factory reset on a Cisco TelePresence MX device from the CLI. Which command should be used? 

A. xConfiguration FactoryReset 

B. xCommand FactoryReset 

C. xCommand SystemUnit FactoryReset 

D. xConfiguration SystemUnit FactoryReset 

Answer: C 


Q38. What is the main difference between Cisco Jabber and Cisco Jabber Video for TelePresence? 

A. Cisco Jabber registers to the Cisco Unified Communications Manager, whereas Cisco Jabber Video for TelePresence registers to the VCS. 

B. Cisco Jabber Video for TelePresence registers to Cisco Unified Communications Manager, whereas Cisco Jabber registers to the VCS. 

C. Cisco Jabber has no video calling capabilities, whereas Cisco Jabber Video for TelePresence has video capabilities. 

D. Cisco Jabber has no presence capabilities, whereas Cisco Jabber Video for TelePresence has presence capabilities. 

E. There is no difference between Cisco Jabber and Cisco Jabber Video for TelePresence. They should not coexist in the same network. 

Answer: A 


Q39. efer to the exhibit. 

Which configuration item shown in the exhibit should be used to assign the internal and external video communication server address for this group of users? 

A. User Settings > Video Address pattern 

B. Administrative Tools > User Settings 

C. Configuration Template > Edit Template 

D. User Import > Configuration 

Answer: C 


Q40. A network engineer is setting up a Cisco TelePresence Content Server. The customer requires live streaming, but does not have a streaming server. Which media should be configured to stream locally from the TelePresence Content Server? 

A. QuickTime 

B. MPEG-4 

C. Flash 

D. Windows Media 

E. Darwin 

Answer: D