High quality of cisco 300 075 test question materials and free samples for Cisco certification for IT engineers, Real Success Guaranteed with Updated cisco 300 075 pdf dumps vce Materials. 100% PASS Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2) exam Today!
Q91. What are the two tasks that you must perform to configure the Service Advertisement Framework forwarder in Cisco Unified Communications Manager? (Choose two.)
A. create VPN groups
B. create VPN profiles
C. create a new Service Advertisement Framework security profile
D. set feature configuration parameters of Call Control Discovery
E. configure Service Advertisement Framework forwarder information
F. enable enterprise parameter for Service Advertisement Framework forwarder
Answer: C,E
Q92. Refer to the exhibit:
The exhibit shows a SAF Forwarder configuration attached to a Cisco Unified Communications Manager.
Which minimum configuration for a Cisco Unified Communications Manager Express SAF Forwarder is needed to establish a SAF neighbor relationship with this SAF Forwarder?
A. router eigrp SAFiservice-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-familyvoice service safprofile trunkroute 1session protocol sip interface Loopback1 transport tcp port 5060!
B. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit- service-family!voice service safprofile trunk-route 1session protocol sip interface Loopback1 transport tcp port 5060!profile dn-block 1 alias-prefix 1972555pattern 1 type extension 4xxx!profile callcontrol 1dn-servicetrunk-route 1dn-block 1dn-block 2!channel 1 vrouter SAF asystem 1subscribe callcontrol wildcardedpublish callcontrol 1!
C. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-family!
D. None of above configurations contain sufficient information.
Answer: C
Explanation:
Incorrect Answer: A, B, D only following configuration is enough router eigrp SAF service-family ipv4 autonomous-system 1 exit-service-family link:
http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6554/ps6599/ps10822/whitepaper_c11-636604.html
Q93. When an H.323 trunk is added for Call Control Discovery, which statement is true?
A. The H.323 trunk is added by selecting Inter-Cluster Trunk (Non-Gatekeeper Controlled) and Device Protocol Inter-Cluster Trunk. The Enable SAF check box should be selected in the trunk configuration.
B. The H.323 trunk is added by selecting Inter-Cluster Trunk (Non-Gatekeeper Controlled) and Device Protocol Inter-Cluster Trunk. The Trunk Service Type should be Call Control Discovery.
C. The H.323 trunk is added by selecting Call Control Discovery Trunk and then selecting
H.323 as the protocol to be used.
D. The H.323 trunk is added by selecting H.323 Trunk, and selecting Inter-Cluster Trunk as the Device Protocol. The destination IP address field is configured as ‘SAF’ to indicate that this trunk is used for SAF.
Answer: A
Explanation:
Reference. Implementing Cisco Unified Communications Manager Part 2 (CIPT2), Chapter3: Implementing Multisite Connections, pg 70-71, Fig 3-14 and Fig 3-15
Q94. When you configure QoS on VCS, which settings do you apply if traffic through the VCS should be tagged with DSCP AF41?
A. Set QoS mode to DiffServ and tag value 32.
B. Set QoS mode to IntServ and tag value to 34.
C. Set QoS mode to DiffServ and tag value 34.
D. Set QoS mode to IntServ and tag value to 32.
E. Set QoS mode to ToS and tag value to 32.
Answer: C
Q95. Which action configures CAC utilizing only Cisco Unified Communications Manager software?
A. Configure Cisco Unified Communications Manager regions.
B. Configure Cisco Unified Communications Manager locations.
C. Configure Cisco Unified Communications Manager RSVP-enabled locations.
D. Configure Cisco Unified Communications Manager MTPs.
Answer: B
Q96. What is the difference between an MGCP gateway and a SIP gateway?
A. An MGCP gateway that dial peers be configured before PSTN calls can be placed and received. The SIP gateway requires no dial peers.
B. An MGCP gateway can be added in Cisco Unified Communications Manager under the Gateway Type field using the gateway model. The SIP gateway can connect to Cisco Unified Communications Manager only through a SIP trunk.
C. A SIP gateway requires a call agent for PSTN calls to be placed and received. An MGCP gateway does not require a call agent for PSTN calls to be placed and received.
D. An MGCP gateway can register with Cisco Unified Communications Manager. A SIP gateway will show status of "Unknown".
E. The SIP gateway must be configured in Cisco Unified Communications Manager using a valid IP address on the gateway. The MGCP gateway must be configured in Cisco Unified
Communications Manager using the domain name.
Answer: B
Q97. What happens if location-based CAC is used and there is no bandwidth available when a remote caller is placed on hold?
A. Cisco Unified Communications Manager sends TOH rather than MOH.
B. Cisco Unified Communications Manager terminates the call.
C. Cisco Unified Communications Manager plays default MOH.
D. Cisco Unified Communications Manager attempts to reconnect the call immediately.
Answer: A
Q98. Refer to the exhibit.
When a user presses a speed dial to +442079460255 when the SAF network is down, which event should occur?
A. The call will reroute via the PSTN with the constructed PSTN number as 442079460255.
B. The call will reroute via the PSTN with the constructed PSTN number as +442079460255.
C. The call will reroute via the PSTN with the constructed PSTN number as 00442079460255.
D. The call will fail because the ToDID is 0:.
E. The call will fail because the called number will be 2079460255.
Answer: B
Q99. Scenario
There are two call control systems in this item. The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 9971 Video IP Phone. The Cisco VCS is controlling the SX20, the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows.
Use the exhibits to answer the following questions.
SX20 System Information
DX650 Configuration
MRGL
DP
Locations
AARG
CSS
Movi Failure
Movi Settings
What two issues could be causing the Cisco Jabber Video for TelePresence failure shown in the exhibit? (Choose two.)
A. Incorrect username and password
B. Wrong SIP domain configured.
C. User is not associated with the device.
D. IP or DNS name resolution issue.
E. CSF Device is not registered.
F. IP Phone DN not associated with the user.
Answer: B,D
Q100. In what Cisco solution is Simple Network-Enabled Auto Provision technology used?
A. Cisco Unified Gateway Duplication
B. Cisco Unified CallManager Redundancy
C. Cisco Unified SRST
D. Cisco Unified Call Survivability
Answer: C
Explanation:
Incorrect Answer: A, B, D When the system automatically detects a failure, Cisco Unified SRST uses Simple Network Auto Provisioning (SNAP) technology to auto-configure a branch office router to provide call processing for the Cisco Unified IP phones that are registered with the router Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmesr st.html
Q101. The network administrator at Enterprise X is creating the guidelines for a new IPT deployment consisting of a large number of remote offices. Every user within Enterprise X is assigned a directory number of 5 digits. Which option might cause an issue in a multisite deployment?
A. Overlapping DID ranges are allocated to each site.
B. The maximum number of IP phones are in use at each remote site.
C. MoH cannot be provided for the remote sites.
D. All media streams are necessarily routed through the central office for calls to establish correctly.
Answer: A
Q102. How is a SIP trunk in Cisco Unified Communications Manager configured for SIP precondition?
A. The configuration is done by selecting a SIP precondition trunk for trunk type.
B. The configuration is automatically selected when RSVP is enabled for the location assigned to the trunk.
C. SIP precondition is configured by selecting E2E for RSVP over SIP on the default SIP profile assigned to the SIP trunk.
D. SIP precondition is configured by configuring a new SIP profile and selecting E2E for RSVP over SIP. The new SIP profile must then be assigned to the SIP trunk.
Answer: D
Q103. Which option is a benefit of implementing CFUR?
A. CFUR is designed to initiate TEHO to reduce toll charges.
B. CFUR can prevent phones from unregistering.
C. CFUR can reroute calls placed to a temporarily unregistered destination phone.
D. CFUR eliminates the need for COR on an ISR.
Answer: C
Q104. Which two configurable options are available to enable Early Offer for calls over a Cisco Unified Communications Manager SIP trunk? (Choose two.)
A. No Media Termination Point Required
B. Media Termination Point Required
C. Accept Audio Codec Preferences in Received Offer
D. Early Offer support for voice and video calls Mandatory (insert MTP if needed)
E. Use Trusted Relay Point
Answer: B,D
Q105. Which two statements about SAF service identifier numbers are true? (Choose two.)
A. They are generated in the format service:sub-service:instance.instance.instance.instance.
B. They are 16-bit decimal identifiers.
C. They are generated in the format data-source:sub-service:instance.matrix.fifty.saf.
D. They are 32-bit decimal identifiers.
E. They are generated in the format data.saf.cucm-publisher.asf@domain.local.
F. They are generated in the format telco.cisco.saf-forwader.db.replicate.data.local.
Answer: A,B