Actualtests offers free demo for cisco 300 075 exam. "Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2)", also known as 300 075 ciptv2 exam, is a Cisco Certification. This set of posts, Passing the Cisco 300 075 pdf exam, will help you answer those questions. The 300 075 pdf Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco 300 075 vce exams and revised by experts!
Q31. Refer to the following exhibit.
Which Cisco IOS SAF Forwarder configuration is correct?
A. Exhibit A
B. Exhibit B
C. Exhibit C
D. Exhibit D
Answer: A
Explanation:
Incorrect Answer: B, C, D Summary steps to configure IOS SAF forwarder is given below
1. enable
2. configure terminal
3. router eigrp virtual-instance-name
4. service-family {ipv4 | ipv6} [vrf vrf-name] autonomous-system autonomous-system-number
5. topology base
6. external-client client_label
7. exit-sf-topology
8. exit-service-family
9. exit
10. service-family external-client listen {ipv4 | ipv6} tcp_port_number
11. external-client client-label
12. username user-name
13. password password-name
14.
Q32. For which VoIP protocol does a gatekeeper provide address translation and control access?
A. H.323
B. SIP
C. Skinny
D. H.248
Answer: A
Q33. Which symbol is required for globalized call routing?
A. +
B. *
C. %
D. /
E. ;
Answer: A
Q34. Refer to the exhibit.
The Cisco Unified Communications Manager at HQ has been configured for end-to-end RSVP. The Cisco Unified Communications Manager at BR has been configured for local RSVP.
RSVP between the locations assigned to the IP phones and SIP trunks at each site are configured with mandatory RSVP. When a call is placed from the IP phone at the BR site to the IP phone at the HQ site, which statement is true?
A. The Cisco Unified Communications Manager at BR will fall back to local RSVP and place the call. No RSVP end-to-end will occur.
B. RSVP end-to-end will occur.
C. The Cisco Unified Communications Manager at BR will use local RSVP. The HQ Cisco Unified Communications Manager will use end-to-end RSVP.
D. The call will fail.
E. The call will proceed as a normal call with no RSVP reservation.
Answer: A
Q35. Which option describes a function of SIP preconditions?
A. SIP preconditions enable end-to-end RSVP over an SIP trunk.
B. SIP preconditions enable RSVP between Cisco IP Phones.
C. SIP preconditions can be enabled in a gatekeeper.
D. SIP preconditions enable end-to-end RSVP for calls through the PSTN.
Answer: A
Q36. Which statement about H.323 Gatekeeper Call Admission Control is true?
A. Gatekeeper Call Admission Control applies to centralized Cisco Unified Communications deployments that use locations based Call Admission Control.
B. Gatekeeper Call Admission Control applies to distributed Cisco Unified Communications deployments.
C. Gatekeeper Call Admission Control applies only to distributed Cisco Unified Communications Express deployments.
D. Gatekeeper Call Admission Control setting is configured in Cisco Unified Communications Manager.
Answer: B
Explanation:
Incorrect Answer: A, C, D in distributed call processing deployments on a simple hub-and-spoke topology, you can implement call admission control with a Cisco IOS gatekeeper. In this design, the call processing agent (which could be a Unified CM cluster, Cisco Unified Communications Manager Express (Unified CME), or an H.323 gateway) registers with the Cisco IOS gatekeeper and queries it each time the agent wants to place an IP WAN call. Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/7x/cac.html#wp1044743
Q37. When using Cisco Unified Communications Manager Express in SRST mode, how many multicast music on hold streams can be utilized by the system at any given time?
A. 3
B. 6
C. 2
D. 4
E. 1
F. 5
Answer: B
Q38. Which statement about technology implementation strategy is true?
A. Cisco Unified Communications Manager Express can be configured to function with no Cisco Unified Communications Manager cluster in the enterprise.
B. Cisco Unified Communications Manager Express in SRST mode can be configured to function with no Cisco Unified Communications Manager cluster in the enterprise.
C. SRST can be configured to function with no Cisco Unified Communications Manager cluster in the enterprise.
D. SRST and MGCP fallback can be configured to function with no Cisco Unified Communications Manager cluster in the enterprise.
Answer: A
Q39. Refer to the exhibit.
Assume that the HQ phones have access to the HQ partition, and BR phones have access to the BR partition. Which set of implementations would best address the overlapping directory number extensions for intersite (WAN) calling between the HQ site and the BR site?
A. Configure a route pattern 8222.[12]XXX for site HQ, and assign it to partition HQ. Configure the called party DDI of Predot.Configure a route pattern for site BR 8111.[1-3]XXX, and assign it to partition BR. Configure called party DDI Predot.Use the local gateway at each site. Prefix the appropriate site code for the calling number.
B. Configure a single route pattern for both sites 8[12,12,12].[1-32]XXX. Use a route list that contains the local route group for each site. Prefix the appropriate site code for the calling number.
C. Configure a translation pattern 8222.[12]XXX for site HQ, and assign it to partition HQ. Use a CSS that contains the partitions for BR phones.Configure a translation pattern 8111.[1-3]XXX for site BR, and assign it to partition BR. Use a CSS that contains the partitions for HQ phones.For both translation patterns, configure the called party DDI of Predot. Prefix the appropriate site code for the calling number.
D. Configure a translation pattern 8222.[12]XXX for site HQ, and assign it to partition BR. Use a CSS that contains the partitions for HQ phones.Configure a translation pattern 8111.[1-3]XXX for site BR, and assign it to partition HQ. Use a CSS that contains the partitions for BR phones.For both translation patterns, configure the called party DDI of Predot. Prefix the appropriate site code for the calling number.
Answer: C
Q40. Which three options are overlapping parameters for roaming when a device is configured for Device Mobility? (Choose three.)
A. MRGL
B. location
C. network locale
D. codec
E. extension
F. device pool
Answer: A,B,C
Q41. Refer to the exhibit.
How does the Cisco Unified Communications Manager advertise dn-block 2?
A. 14087071222 with number type international
B. +14087071222 with number type international
C. +14087071222
D. 14087071222
Answer: C
Q42. Which statement best describes globalized call routing in Cisco Unified Communications Manager?
A. All incoming calling numbers on the phones are displayed as an E.164 with the + prefix.
B. Call routing is based on numbers represented as an E.164 with the + prefix format.
C. All called numbers sent out to the PSTN are in E.164 with the + prefix format.
D. The CSS of all phones contain partitions assigned to route patterns that are in global format.
E. All phone directory numbers are configured as an E.164 with the + prefix.
Answer: B
Explanation:
Incorrect Answer: A, C, D, E For the destination to be represented in a global form common to all cases, we must adopt a global form of the destination number from which all local forms can be derived. The + sign is the mechanism used by the ITU's E.164 recommendation to represent any PSTN number in a global, unique way. This form is sometimes referred to as a fully qualified PSTN number. Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/7x/dialplan.html#wp1153205
Q43. Scenario
There are two call control systems in this item. The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 9971 Video IP Phone. The Cisco VCS is controlling the SX20, the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows.
Use the exhibits to answer the following questions.
SX20 System Information
DX650 Configuration
MRGL
DP
Locations
AARG
CSS
Movi Failure
Movi Settings
A new DX650 IP phone with MAC address D0C7.8914.132D, IP address is 172.18.32.119 has been added to the Cisco Unified Communications Manager, but is not registering properly.
What is causing this failure?
A. Device Pool cannot be default.
B. The DX650 is the incorrect calling search space.
C. The DX650 Phones does not support SIP.
D. The location Hub_None has not been activated.
E. The DX650’s MAC address is incorrect in the Cisco UCM.
Answer: E
Explanation:
From the screen capture below we can see that the DX650 phone’s MAC address was incorrectly entered as D0C78914131D, not D0C78914132D.
Q44. Which two configurations are needed to implement SRST in Cisco Unified Communications Manager? (Choose two.)
A. SRST Gateway setting in Cisco Unified Communications Manager
B. SRST Reference configured in Cisco Unified Communications Manager
C. Device Pool SRST Reference setting
D. Call Manager Group setting
E. Cisco Unified Communications Locations setting
Answer: B,C
Q45. While configuring Call Survivability in Cisco Unified Communications Manager, what step is mandatory to reach remote sites while in SRST mode?
A. Enable Cisco Remote Site Reachability.
B. Configure CFUR.
C. Enable the SRST checkbox in the MGCP gateway.
D. Configure the H.323 gateway for SRST in Cisco Unified Communications Manager.
E. Enable the Failover Service parameter.
Answer: B
Explanation:
Incorrect Answer: A, C, D, E Call Forward Unregistered (CFUR) functionality provides the automated rerouting of calls through the PSTN when an endpoint is considered unregistered due to a remote WAN link failure Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/8x/models.html