Master the ccnp routing and switching route 300 101 official cert guide ROUTE Implementing Cisco IP Routing content and be ready for exam day success quickly with this Actualtests 300 101 route pdf pdf exam. We guarantee it!We make it a reality and give you real ccnp dumps 300 101 questions in our Cisco ccnp 300 101 dumps braindumps.Latest 100% VALID Cisco 9tut ccnp 300 101 Exam Questions Dumps at below page. You can use our Cisco route 300 101 braindumps and pass your exam.

P.S. Free 300-101 software are available on Google Drive, GET MORE: https://drive.google.com/open?id=1BHb398qwKUUDgc3Vdghj3SxO9n6grhvU


New Cisco 300-101 Exam Dumps Collection (Question 6 - Question 15)

Question No: 6

A network engineer has configured a tracking object to monitor the reachability of IP SLA 1. In order to update the next hop for the interesting traffic, which feature must be used in conjunction with the newly created tracking object to manipulate the traffic flow as required?

A. SNMP

B. PBR

C. IP SLA

D. SAA

E. ACLs

F. IGP

Answer: B


Question No: 7

Which SNMP verification command shows the encryption and authentication protocols that are used in SNMPv3?

A. show snmp view

B. show snmp

C. show snmp user

D. show snmp group

Answer: C


Question No: 8

Refer to the exhibit.

Which statement is true?

A. RTA will redistribute the RIP routers into the NSSA as type 7 LSAs. RTB will translate the type 7 LSAs into type LSAs and flood them throughout the OSPF backbone.

B. RTA will redistribute the RIP routers into the NSSA as type 7 LSAs. RTB will flood the type 7 LSAs throughout the backbone.

C. RTA will redistribute the RIP routers into the NSSA as type 5 LSAs. RTB will flood the type 5 LSAs throughout the backbone.

D. RTA will redistribute the RIP routers into the NSSA as type 5 LSAs. RTB will translate the type of 5 LSAs unto type 7 LSAs and flood them throughout the OSPF backbone.

E. RTA will not redistribute the RIP routers into the NSSA.

Answer: A


Question No: 9

A network engineer has set up VRF-Lite on two routers where all the interfaces are in the same VRF. At a later time, a new loopback is added to Router 1, but it cannot ping any of the existing interfaces. Which two configurations enable the local or remote router to ping the loopback from any existing interface? (Choose two.)

A. adding a static route for the VRF that points to the global route table

B. adding the loopback to the VRF

C. adding dynamic routing between the two routers and advertising the loopback

D. adding the IP address of the loopback to the export route targets for the VRF

E. adding a static route for the VRF that points to the loopback interface

F. adding all interfaces to the global and VRF routing tables

Answer: A,B


Question No: 10

Your Company trainee asks you, in the context of IPv6 and OSPF, what best describes a type 9 LSA? What should you tell her?

A. Link LSA

B. Interarea prefix LSA for ABRs

C. Router LSA

D. Switch LSA

E. Intra-area prefix LSA

F. None of the above

Answer: E


Question No: 11

Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4 tunnel?

A. A manually configured IPv6 in IPv4 tunnel allows multiple IPv4 destinations.

B. An automatic 6to4 tunnel allows multiple IPv4 destinations.

C. A manually configured IPv6 in IPv4 tunnel does not require dual-stack (IPv4 and IPv6) routers at the tunnel endpoints.

D. An automatic 6to4 tunnel does not require dual-stack (IPv4 and IPv6) routers at the tunnel endpoints.

Answer: B

Explanation:

An automatic 6to4 tunnel allows isolated IPv6 domains to be connected over an IPv4 network to remote IPv6 networks. The key difference between automatic 6to4 tunnels and manually configured tunnels is that the tunnel is not point-to-point; it is point-to-multipoint -> it allows multiple IPv4 destinations .

Manually 6to4 is point-to-point -> only allows one IPv4 destination.

Configuring 6to4 (manually and automatic) requires dual-stack routers (which supports both IPv4 & IPv6) at the tunnel endpoints because they are border routers between IPv4 & IPv6 networks.

(Reference: http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6- tunnel_ps6441_TSD_Products_Configuration_Guide_Chapter.html#wp1055515)


Question No: 12

Your company uses Voice over IP (VoIP). The system sends UDP datagrams containing the voice data between communicating hosts. When areas of the network become busy, some

of the datagrams arrive at their destination out of order. What happens when this occurs?

A. UDP will send an ICMP Information request message to the source host.

B. UDP will pass the information in the datagrams up to the next OSI layer in the order in which they arrive.

C. UDP will drop the datagrams that arrive out of order.

D. UDP will use the sequence numbers in the datagram headers to reassemble the data into the

Answer: B


Question No: 13

Which option must be configured on a target device to use time stamping to accurately represent response times using IP SL ?

A. Responder

B. Jitter value

C. TCP Connect

D. ICMP Echo

Answer: D


Question No: 14

Refer to the exhibit. The DHCP client is unable to receive a DHCP address from the DHCP server. Consider the following output:

hostname RouterB

!

interface fastethernet 0/0

ip address 172.31.1.1 255.255.255.0

interface serial 0/0

ip address 10.1.1.1 255.255.255.252

!

ip route 172.16.1.0 255.255.255.0 10.1.1.2

Which configuration is required on the Router B fastethernet 0/0 port in order to allow the DHCP client to successfully receive an IP address from the DHCP server?

A. RouterB(config-if)# ip helper-address 172.16.1.2

B. RouterB(config-if)# ip helper-address 172.16.1.1

C. RouterB(config-if)# ip helper-address 172.31.1.1

D. RouterB(config-if)# ip helper-address 255.255.255.255

Answer: A


Question No: 15

Which statement is true?

A. RADIUS uses TCP, and TACACS+ uses UDP.

B. RADIUS encrypts the entire body of the packet.

C. TACACS+ encrypts only the password portion of a packet.

D. TACACS+ separates authentication and authorization.

Answer: D


Recommend!! Get the Free 300-101 dumps in VCE and PDF From Dumpscollection, Welcome to download: http://www.dumpscollection.net/dumps/300-101/ (New 436 Q&As Version)