Cause all that matters here is passing the Alcatel-Lucent 4A0-108 exam. Cause all that you need is a high score of 4A0-108 Alcatel-Lucent Multicast Protocols exam. The only one thing you need to do is downloading Testking 4A0-108 exam study guides now. We will not let you down with our money-back guarantee.
2021 Sep 4A0-108 vce
Q41. Which MAC address will the IPv4 multicast address 239.33.42.107 be translated to?
A. 01-00-5e-a1-2a-6b
B. 01-00-5e-21-2a-6b
C. 01-00-5e-21-2c-6c
D. 00-01-5e-a1-2a-6b
E. 00-01-5e-21-2a-6b
F. 00-01-5e-a1-2c-6b
Answer: B
Q42. When forwarding a multicast frame, the normal behavior for a LAN switch without IGMP snooping enabled is to forward the frame based on the same rules as if it were:
A. A unicast frame with a known destination in the forwarding table
B. A unicast frame with an unknown destination in the forwarding table
C. A unicast frame with a known source in the forwarding table
D. A unicast frame with an unknown source in the forwarding table
Answer: B
Q43. Which of the following protocols are used for IPv6 multicast?
A. IGMPv3 and MBGP
B. MLD and MBGP
C. IGMPv3 and PIM SM
D. MLD and PIM SM
Answer: D
Q44. Under what circumstances will the multicast data flow remain on the Shared Path Tree in a PIM ASM network?
A. When multicast traffic is below a configured threshold
B. It will always remain on the Shared Path Tree
C. It will never remain on the Shared Path Tree
D. When PIM Dense Mode is in use
Answer: A
Q45. Which of the following statements is true regarding BSR and RP?
A. The same router cannot be configured as a BSR candidate and as a static RP
B. The same router cannot be a candidate-RP and a BSR-candidate at the same time
C. There is only one active RP in a multicast routing domain at anytime
D. There is only one elected BSR in a multicast routing domain at anytime
Answer: D
Avant-garde 4A0-108 training:
Q46. Refer to the configuration exhibit.
Which of the following statements is true?
A. 2 static RP's cannot be configured on the same device
B. 10.10.10.24 will be RP for 230.1.1.1 and 10.10.10.66 will be RP for 234.1.1.1
C. 10.10.10.24 will be RP for 234.1.1.1 and 10.10.10.66 will be RP for 230.1.1.1
D. 2 static RP's both with override cannot be configured on the same device
Answer: C
Q47. Which of the following is a characteristic of a packet with a destination address in the Local Network Control Block address range?
A. A packet with this address is always forwarded throughout the multicast routing domain but never forwarded outside the multicast routing domain
B. A packet with this address can only be processed by a router
C. A packet with this address is never forwarded beyond the local link unless the TTL is greater than 1
D. A packet with this address is never forwarded beyond the local link regardless of the TTL
Answer: D
Q48. When a BSR message with a higher priority is seen, will a new BSR election occur?
A. No, the new election only occurs when the elected BSR fails
B. Yes, after a bootstrap message wait interval
C. Yes, immediately
D. Depends on the local configuration of whether to allow the new election or not
Answer: C
Q49. Refer to the configuration exhibit.
What will happen when this router receives an IGMPv3 exclude none report for group 232.1.1.1?
A. The router will propagate a (*, 239.1.1.1) join towards RP if it exists
B. The router will randomly pick a source from 192.168.1.1 and 192.168.1.2 and send an (S.G)join towards the source
C. The IGMPv3 report will be dropped and a log about misconfiguration will be generated
D. The router will send a PIM (192.168.1.1,232.1.1.1) Join
Answer: D
Q50. Which of the following multicast packets can be forwarded on the Internet?
A. A multicast packet destined to FF70:: 1234
B. A multicast packet destined to FF1E:: 1234
C. A multicast packet destined to FF02:: 1234
D. A multicast packet destined to FF3A:: 1234
Answer: B