The actual Juniper educate would probably assist the JN0-691 college students so that you can pick up its high end as opposed to uneducated. Whilst exactly how may possibly graduate students with no working experience successfully pass JN0-691, and acquire a good Juniper certification? The reasons why lie from the diverse test skills along with difficulties arriving up. Assessment question traditional bank, question saying skills, practicing fraudulence, being disloyal, and so forth. dominate caused by very poor managing in the field of Juniper.

2021 Nov JN0-691 simulations

Q61. What controls the CLI process? 

A. chassis control daemon 

B. management daemon 

C. routing protocol process 

D. device control daemon 

Answer: B 


Q62. Click the Exhibit button. -- Exhibit --user@R1> show route 2.2.2.2 user@R1> show route forwarding-table destination 2.2.2.2 Routing table:default.inet Internet: Destination Type RtRef Next hop Type Index NhRef Netif 2.2.2.2/32 user 1 17.1.1.2 ucst 642 9 xe-1/1/0.0 -- Exhibit --Referring to the exhibit, which statement is true about transit traffic sent to 2.2.2.2? 

A. R1 will discard the packet. 

B. R1 will forward the packet. 

C. R1 will redirect the packet to the Routing Engine. 

D. R1 will reject the packet. 

Answer: B 


Q63. -- Exhibit –

user@router> show system switchover Graceful switchover: On Configuration databasE.Ready Kernel databasE.Version incompatible Peer statE.Steady State -- Exhibit --You have enabled graceful Routing Engine switchover (GRES). During verification, you switched mastership and all interfaces went down. Referring to the output shown in the exhibit, why did the interfaces go down? 

A. The synchronization failed because the Junos OS version on the backup is incompatible with the version running on the master. 

B. The synchronization failed because the Junos OS version on the backup does not support GRES. 

C. The synchronization failed because the Routing Engine models are different between the master and backup. 

D. The synchronization failed because the master Routing Engine cannot communicate with the backup Routing Engine. 

Answer: A 


Q64. Which process is responsible for managing interface devices on the system? 

A. chassis daemon 

B. device control daemon 

C. routing protocol process 

D. management daemon 

Answer: B 


Q65. By default, what are three packet header fields used for load balancing on an SRX Series device? (Choose three.) 

A. IP options B. destination port number 

C. destination IP address D. protocol 

E. incoming interface index 

Answer: B, C, D 


Abreast of the times JN0-691 dumps:

Q66. An OSPF adjacency is not forming between two routers directly connected using SONET/SDH interfaces. What are two reasons for this behavior? (Choose two.) 

A. The data-link connection is down. 

B. The network type on both routers is point-to point. 

C. The IP subnets on both routers are different. 

D. The subnet masks on both routers are different. 

Answer: A, C 


Q67. What information would be learned by reviewing the output from theshow system uptimecommand? (Choose three.) 

A. the date and time that the configuration last changed 

B. the current software version 

C. the current date and time 

D. the date and time when the last user logged into the device 

E. the dateand time that the system booted 

Answer: A, C, E 


Q68. An OSPF adjacency is not forming between two routers directly connected using Ethernet. 

What are three reasons for this behavior? (Choose three.) 

A. The physical connection is down. 

B. The IP subnets on both routers are different. 

C. The subnet masks on both routers are the same. 

D. The network type on both routers is point-to-point. 

E. The area numbers on both routers are different. 

Answer: A, B, E 


Q69. An interface on your Junos device reports a device-level flag of Loopback-detected. What is causing this flag to be reported? 

A. The link-layer protocol failed to successfully connect with the remote endpoint. 

B. The interface was administratively disabled. 

C. The interface is in promiscuous mode and sees frames addressed to all physical addresses on the medium. 

D. The interface link layer received its own frames. 

Answer: D 


Q70. Which monitoring protocol allows you to securely monitor Junos devices? 

A. SNMPv3 

B. SNMPv1 

C. SNMPv2c 

D. SNMPv2u 

Answer: A