Want to know Actualtests 200 355 wifund Exam practice test features? Want to lear more about Cisco Implementing Cisco Wireless Network Fundamentals certification experience? Study Precise Cisco ccna wireless 200 355 official cert guide answers to Latest ccna wireless 200 355 questions at Actualtests. Gat a success with an absolute guarantee to pass Cisco 200 355 wifund (Implementing Cisco Wireless Network Fundamentals) test on your first attempt.

Q21. A customer has ordered a Cisco 5760 Wireless Controller. What speed and quantity of ports are needed for full-speed operation? 

A. 6 x 1 Gb 

B. 6 x 10 Gb 

C. 2 x 10 Gb 

D. 2 x 1 Gb 

E. 8 x 1 Gb 

F. 8 x 10 Gb 

Answer:


Q22. Which Cisco AnyConnect module allows troubleshooting for core AnyConnect problems? 

A. telemetry 

B. web security 

C. VPN 

D. NAM 

E. DART 

F. posture 

G. CSSC 

Answer:


Q23. RAG DROP 

Answer: 


Q24. What are the interface statuses of a lightweight AP working in rogue-detection mode? 

A. radios turned off, Ethernet interface up 

B. radios and Ethernet interfaces up 

C. radios turned on, Ethernet interface shut down 

D. radios turned on, Ethernet interface status controlled by Cisco WLC 

Answer:


Q25. Which key is established using the four-way handshake during the WPA authentication process? 

A. Pairwise Master Key 

B. Pairwise Multiple Key 

C. Pairwise Session Key 

D. Pairwise Transient Key 

E. Pairwise Transverse Key 

Answer:


Q26. In the current RF environment, the noise floor is -95 dBm. A tablet needs an SNR of 25 dB to transmit at the required speed. What must the RSSI cell edge be to meet the required SNR? 

A. -120 dBm 

B. -90 dBm 

C. -70 dBm 

D. -60 dBm 

E. -50 dBm 

Answer:


Q27. What tool can be used to increase accuracy of WCS heat maps? 

A. Map Editor 

B. Planning Tool 

C. CleanAir 

D. Cisco Spectrum Expert 

Answer:


Q28. A WLAN deployment uses a combination of Cisco Aironet 1260 APs and multiple Cisco 5500 Wireless LAN Controllers to provide wireless LAN access to end-users. The network administrator has decided to use DHCP Option 43 to enable the APs to discover the wireless LAN controllers. 

When configuring the DHCP scope, which format should be used for the Cisco WLC addresses? 

A. a comma-separated ASCII string of Cisco WLC AP-manager addresses 

B. a comma-separated ASCII string of Cisco WLC management addresses 

C. a comma-separated ASCII string of Cisco WLC virtual IP addresses 

D. a hexadecimal string of Cisco WLC AP-manager addresses 

E. a hexadecimal string of Cisco WLC management addresses 

F. a hexadecimal string of Cisco WLC virtual IP addresses 

Answer:


Q29. The network administrator receives complaints of slow wireless network performance and performs a sniffer trace of the wireless network in preparation for migration to 802.11n. The sample capture shows frames that contains AP beacons with NonERP_Present bit set to 1 and frames with RTS/CTS. 

Which two conclusions can be interpreted from these frames? (Choose two.) 

A. The network is performing slowly because 802.11n clients are already mixed with 802.11g clients. 

B. The network is performing slowly because 802.11b clients still exist in the network. 

C. The network is performing slowly because a wireless client is incorrectly configured, which results in RF interference. 

D. Possible 802.11b wireless clients are located only in the AP cell radius where the sniffer capture was performed. 

E. Possible 802.11b wireless clients could be located anywhere in the wireless network. 

Answer: B,E 


Q30. What two capabilities would be present on a wireless client device that supports CCXv3? (Choose two.) 

A. WPA2 

B. 802.1x 

C. PEAP-MSCHAP 

D. NAC 

E. MFP 

F. EAP-TLS 

Answer: A,B