Q51. A network engineer must perform posture assessments on Cisco ASA remote access VPN clients and control their network access based on the results. What mode is the Cisco best practice NAC deployment design for this situation?
A. Layer 2 in-band real IP gateway mode
B. Layer 2 out-of-band real IP gateway mode
C. Layer 3 in-band virtual gateway mode
D. Layer 3 out-of-band virtual gateway mode
Answer: C
Q52. What feature is a benefit of using Cisco UCS blade servers for data center virtualization?
A. guest VM high availability
B. converged LAN and SAN infrastructure
C. host based etherchannel
D. built-in hypervisor
Answer: B
Q53. An organization is designing the IP allocation of a new site. It currently has 12 separate IP
segments. Each segment must be /24, accommodate 25% of growth, and be easily summarized.
Which summarized IP block can be subnetted to meet these requirements?
A. /18
B. /19
C. /20
D. /21
Answer: C
Q54. Which unique EIGRP feature allows for faster Layer 3 convergence?
A. fast EIGRP timers
B. feasible successors
C. hybrid routing protocol
D. Cisco proprietary protocol
Answer: B
Q55. When designing the routing for an Enterprise Campus network it is important to keep which of the following route filtering aspects in mind?
A. Filtering is only useful when combined with route summarization
B. It is best to filter (allow) the default and summary prefixes only in the Enterprise Edge to remote sites or site-to-site IPsec VPN networks
C. IGPs (for example EIGRP or OSPF) are superior to route filtering in avoiding inappropriate transit traffic through remote nodes or inaccurate or inappropriate routing updates
D. The primary limitation of router filtering is that it can only be applied on outbound updates
Answer: B
Q56. Refer to the exhibit.
The network engineer wants to ensure that receiver A does not receive traffic from the video conference.
For multicast traffic, where must the filtering be placed to fulfill that requirement?
A. R1
B. Video Conference
C. A
D. S1
E. R2
Answer: D
Q57. Which feature can be used in the Cisco Nexus 7000 to create a snapshot of the current configuration?
A. Cisco FabricPath
B. HSRP
C. Rollback
D. vPC
Answer: C
Q58. An engineer is designing an address plan. Which IPv6 prefix removes any consideration regarding the number of hosts per subnet?
A. /32
B. /48
C. /64
D. /96
Answer: C
Q59. Which Nexus feature enables you to support server connectivity with one topology and address requirement for both high availability and high bandwidth?
A. vPC
B. vPC+
C. Stackwise
D. EvPC
Answer: D
Q60. Which network virtualization technology provides logical isolation of network traffic at Layer 3?
A. VSS
B. VLAN
C. VRF-Lite
D. MEC
Answer: C