Testking aerospatiale alenia atr 42 300 320 Questions are updated and all 300 320 vce answers are verified by experts. Once you have completely prepared with our 300 320 arch dumps exam prep kits you will be ready for the real aerospatiale alenia atr 42 300 320 exam without a problem. We have Far out Cisco 300 320 arch dumps dumps study guide. PASSED cisco 300 320 First attempt! Here What I Did.

Q121. Which option is the Cisco recommendation for data oversubscription for access ports on the access-to-distribution uplink? 

A. 4 to 1 

B. 20 to 1 

C. 16 to 1 

D. 10 to 1 

Answer:


Q122. Which technology can block interfaces and provide a loop-free topology? 

A. STP 

B. VSS 

C. VLAN 

D. vPC 

Answer:


Q123. Which of the following facts must be considered when designing for IP telephony within an Enterprise Campus network? 

A. Because the IP phone is a three-port switch, IP telephony extends the network edge, impacting the Distribution layer. 

B. Video and voice are alike in being bursty and bandwidth intensive, and thus impose requirements to be lossless, and have minimized delay and jitter. 

C. IP phones have no voice and data VLAN separation, so security policies must be based on upper layer traffic characteristics. 

D. Though multi-VLAN access ports are set to dot1q and carry more than two VLANs they are not trunk ports. 

Answer:


Q124. Which option prevents the dropping of asymmetrically routed packets in active/active failover paired firewalls? 

A. Nothing can be done to prevent this from happening. 

B. Configure different policies on both firewalls. 

C. Assign similar interfaces on each firewall to the same asymmetric routing group. 

D. Assign similar interfaces on each firewall to a different asymmetric routing group. 

Answer:


Q125. A customer with a single Cisco Adaptive Security Appliance wants to separate multiple segments of the e-commerce network to allow for different security policies. What firewall technology accommodates these design requirements? 

A. virtual contexts 

B. private VLANs 

C. admission control 

D. virtual private network 

Answer:


Q126. Which multicast address must be available for FHRP advertisements in a multivendor environment? 

A. 224.0.0.9 

B. 224.0.0.18 

C. 224.0.0.102 

D. 224.0.0.2 

Answer:


Q127. Which statement is the most accurate regarding IPsec VPN design for an Enterprise Campus environment? 

A. VPN device IP addressing must align with the existing Campus addressing scheme. 

B. The choice of a hub-and-spoke or meshed topology ultimately depends on the number of remotes. 

C. Sizing and selection of the IPsec VPN headend devices is most affected by the throughput bandwidth requirements for the remote offices and home worker 

D. Scaling considerations such as headend configuration, routing protocol choice, and topology have the broadest impact on the design. 

Answer:


Q128. DRAG DROP 

Answer: 


Q129. Summary address blocks can be used to support which network application? 

A. QoS 

B. IPsec tunneling 

C. Cisco TrustSec 

D. NAT 

E. DiffServ 

Answer:


Q130. A network design engineer has been asked to reduce the size of the SPT on an IS-IS broadcast network. Which option should the engineer recommend to accomplish this task? 

A. Configure the links as point-to-multipoint. 

B. Configure QoS in all links. 

C. Configure a new NET address. 

D. Configure the links as point-to-point. 

Answer:


Q131. Which two options improve BGP scalability in a large autonomous system? (Choose two.) 

A. route reflectors 

B. route redistribution 

C. confederations 

D. communities 

Answer: A,C 


Q132. Which two of these are characteristics of multicast routing? (Choose two.) 

A. multicast routing uses RPF. 

B. multicast routing is connectionless. 

C. In multicast routing, the source of a packet is known. 

D. When network topologies change, multicast distribution trees are not rebuilt, but use the original path 

E. Multicast routing is much like unicast routing, with the only difference being that it has a a group of receivers rather than just one destination 

Answer: A,C 


Q133. What two sensor types exist in an IDS/IPS solution? (Choose two.) 

A. host 

B. anomaly based 

C. policy based 

D. network based 

E. signature 

Answer: A,D 


Q134. A network engineer is implementing virtualization into the enterprise network. Which system should be used to address policy enforcement at the distribution layer? 

A. Cisco IOS based firewall 

B. multilayer switches 

C. integrated firewall services 

D. identity services engine 

E. intrusion protection systems 

Answer:


Q135. An engineer notices that many BGP peers utilize the same configuration parameters. What can the engineer configure to simplify BGP neighbor statements and generate more efficient BGP peer updates? 

A. peer groups 

B. policy templates 

C. session templates 

D. peer address families 

Answer: