Q91. Refer to the exhibit. Which option should be the default gateway for the PC1 that is shown? 

A. 10.3.2.4 

B. 10.2.2.2 

C. 10.2.2.1 

D. 10.2.2.3 

Answer: A 


Q92. To which network layer should Cisco Express Forwarding be tuned to support load balancing and to make more informed forwarding decisions? 

A. Layer 1 

B. Layer 2 

C. Layer 3 

D. Layer 4 

E. Layer 5 

F. Layer 6 

G. Layer 7 

Answer: D 


Q93. Which three statements about Network Attached Storage are correct? (Choose three.) 

A. Data is accessed using NFS or CIFS. 

B. Data is accessed at the block level. 

C. NAS is referred to as captive storage. 

D. Storage devices can be shared between servers. 

E. A NAS implementation is not as fast as a DAS implementation. 

Answer: A,D,E 


Q94. What is an advantage of having an out-of-band management? 

A. It is less expensive to have an out-of-band management. 

B. Network devices can still be managed, even in case of network outage. 

C. There is no separation between the production network and the management network. 

D. SSH protocol must be used to manage network devices. 

Answer: B 


Q95. A network administrator wants to provide high availability in a data center environment by making sure that there is no reconvergence of Layer 2 and Layer 3 protocols when there is a Layer 3 switch failure..Which Cisco Nexus feature fulfills this purpose? 

A. ISSU 

B. VSS 

C. vPC 

D. MEC 

Answer: C 


Q96. A network engineer is designing a network that must incorporate seamless failover when a link failure occurs between the core and distribution layer. What two technologies will allow this? (Choose two.) 

A. ECMP 

B. RSTP 

C. MEC 

D. GLBP 

E. HSRP 

Answer: A,C 


Q97. What are two of Cisco's best practices at the access layer to ensure rapid link transitions and VLAN consistency? (Choose two.) 

A. Deploy RPVST 

B. Deploy MSTP 

C. Utilize VTP in server/client mode 

D. Utilize VTP in transparent mode 

E. VLANs span entire network 

F. Portfast applied on distribution uplinks 

Answer: A,D 


Q98. A network design engineer has been asked to reduce the size of the SPT on an IS-IS broadcast network. Which option should the engineer recommend to accomplish this task? 

A. Configure the links as point-to-multipoint. 

B. Configure QoS in all links. 

C. Configure a new NET address. 

D. Configure the links as point-to-point. 

Answer: D 


Q99. Which option describes why duplicate IP addresses reside on the same network in Cisco network design? 

A. HSRP designed network 

B. using Cisco ACE in active/passive mode 

C. VRRP designed network 

D. running multiple routing protocols 

Answer: B 


Q100. Which two design principles should be followed to scale EIGRP properly? (Choose two.) 

A. Ensure that the network design follows a structured hierarchical topology. 

B. Utilize route summarization on edge devices. 

C. Implement multiple autonomous systems, regardless of the size of the network. 

D. Tune EIGRP delay metric on all core devices. 

E. Configure offset lists on the network border. 

Answer: A,B