Act now and download your Cisco 642-980 test today! Do not waste time for the worthless Cisco 642-980 tutorials. Download Abreast of the times Cisco Troubleshooting Cisco Data Center Unified Fabric exam with real questions and answers and begin to learn Cisco 642-980 with a classic professional.

Q41. A customer is deploying FCoE in its networ and has found that the connected host does not support FIP. Which command will be useful in troubleshooting this issue? 

A. show platform fcoe_mgr info interface vfc id 

B. show platform fcoe_mgr info software interface vfc id 

C. show platform software fcoe_mgr info interface vfc id 

D. show platform software interface fcoe_mgr info vfc id 

Answer: C 


Q42. Fibre Channel traffic on VSAN 12 between N5K2 and MDS9124-2 is degraded. Which statement explains the cause of this degradation? 

A. Performance is decreased by half due to the incorrect port type being used. 

B. The load-balancing scheme for VSAN 12 should be src-id/dst-id. 

C. B2B credits on N5K2 should be increased to 128. 

D. A VSAN port channel must be configured between N5K2 and MDS9124-2. 

Answer: D 


Q43. Which statement is true regarding STP? 

A. When the spanning-tree topology is calculated based on default parameters, the path between the source and destination end stations in a switched network might not be ideal. 

B. The path between the source and the destination end stations is always ideal with the default spanning-tree parameter. 

C. The path between the source and the destination end stations is determined by the speed of the link; the slowest link speed will become the root port during the election. 

D. The path between the source and the destination end stations is determined by the lowest MAC address; the lowest MAC address will become the root port during the election. 

Answer: A 


Q44. A customer calls you to report that it receives an error when entering the pinning max-links 4 command in FEX configuration mode on its Cisco Nexus 5596T Switch. Which of these is a likely cause for this condition? 

A. The FEX fabric interface is down. 

B. The transceiver is incorrect. 

C. A fabric interface is in a port channel. 

D. The fabric interface switchport mode is set to Access. 

E. Only two fabric interfaces are connected. 

Answer: C 


Q45. In Cisco NX-OS releases prior to 5.2, how should the copp-system-p-policy policy be modified to change how the supervisor module is protected from DoS attacks? 

A. Modify the policy map type control-plane copp-system-policy. 

B. Open DCNM and modify the "copp-system-p-policy" policy object. 

C. Re-run the setup utility and apply a new CoPP profile. 

D. In Cisco NX-OS versions prior to 5.2, the CoPP system profile can only be modified from the CMP CLI. 

Answer: C 


Q46. Which command is critical in order for OTV edge devices to maintain an overlay adjacency with their local peers in a multihomed site via the join interfaces across the Layer 3 network domain? 

A. otv site-identifier 

B. otv extend-vlan 

C. otv site-vlan 

D. otv use-adjacency-server unicast-only 

Answer: A