High quality of H12-211 exam cram materials and rapidshare for HUAWEI certification for examinee, Real Success Guaranteed with Updated H12-211 pdf dumps vce Materials. 100% PASS Huawei Certified Datacom Associate-Huawei Networking Technology and Device (HCDA-HNTD) exam Today!
2021 Oct H12-211 download
Q191. (Topic 3)
In the frame relay network, the bandwidth of each virtual circuit for the control strategy is the correct description
A. In the Tc, the amount of data transfer when the user is not greater than Bc, to continue receiving the frame transmission
B. When the user data transmission is greater than Bc Bc and Be, but not greater than the sum, it will send more than frame the scope of Bc DE position "1"
C. When the Tc in the user data transmission is greater than the sum of Bc and Be, the frame will exceed the scope of the DE position "1"
D. When the Tc in the user data transmission is greater than the sum of Bc and Be, it will exceed the range of frames discarded
Answer: A,B,D
Q192. (Topic 3)
In the RSTP standard, and not directly connected to a terminal connected to the other bridge port is defined as (), such port can directly enter the forwarding state, without any delay.
A. Fast port
B. backup port
C. Root port
D. Edge port
Answer: D
Q193. (Topic 4)
A router routing table is as follows:
Routing Tables:
Destination / Mask Proto Pre Cost NextHop Interface
2.0.0.0
/ 8 Direct 0 0 2.2.2.1 Serial0 2.2.2.1/32 Direct 0 0 2.2.2.1 Serial0 2.2.2.2/32 Direct 0 0 127.0.0.1 LoopBack0
3.0.0.0
/ 8 Direct 0 0 3.3.3.1 Ethernet0 3.3.3.1/32 Direct 0 0 127.0.0.1 LoopBack0
10.0.0.0 / 8 Static 60 0 2.2.2.1 Serial0
127.0.0.0 / 8 Static 0 0 127.0.0.1 LoopBack0
127.0.0.1/32 Direct 0 0 127.0.0.1 LoopBack0
At this time when the router from the Ethernet port sent to the 11.1.1.1 host receives a packet, the router how to deal with
A. lost
B. forward from Serial0
C. forward from Ethernet0
D. forwarding from LoopBack0
Answer: A
Q194. (Topic 3)
Port mirroring configuration, which of the following steps must be configured ().
A. redirect
B. acl
C. classify
D. behavior
Answer: B
Q195. (Topic 1)
: 183
Has been fragmented datagram may be fragmented again. Included in the IP header () for the fragmentation and re-assembled to provide enough information.
A. Type of Service
B. Flag
C. Fragment Offset
D. header checksum
Answer: D
Most recent H12-211 training:
Q196. (Topic 3)
A switch part of the information displayed below, then the port's PVID is [Quidway] display interface Ethernet 1/0/1 ... ... Mdi type: auto Port link-type: access Tagged VLAN ID: none Untagged VLAN ID: 5
A. 0
B. 1
C. 5
D. lack of information, unknown
Answer: C
507. (Topic 3)
In HDLC, the mark the start and end frame fields for a fixed value, it is
A. 11111111
B. 01111110
C. 00000000
D. 11111110
Answer: B
Q197. (Topic 2)
In the standard Ethernet, to avoid multiple devices at the same time to seize the line mechanism called
A. CSMA / CA
B. CSMA / DA
C. CSMA / C, D
D. CSMA / A, C
Answer: C
Q198. (Topic 4)
For the RIP protocol, you can reach the target network hops (the number of routers through which) up to
A. 12
B. 15
C. 16
D. No limit
Answer: B
Q199. (Topic 4)
In the router, type the command displays RIP routing information, see the show results are: peer 192.168.1.2 on Serial0/0/1, which is the router 192.168.1.2 ().
A. RIP neighbor address
B. Enable the RIP protocol address of the interface
C. RIP routing next hop address
D. RIP protocol transport address
Answer: A
Q200. (Topic 2)
201.1.0.0/21 segment of the broadcast address is
A. 201.1.7.255
B. 201.1.0.255
C. 201.1.1.255
D. 201.0.0.255
Answer: A
198. (Topic 2)
100BaseTX Fast Ethernet cable and the transmission distance 100BaseT4 ().
A. 100m
B. 550m
C. 1000m
D. 2000m
Answer: A