Certleader JN0-103 Questions are updated and all JN0-103 answers are verified by experts. Once you have completely prepared with our JN0-103 exam prep kits you will be ready for the real JN0-103 exam without a problem. We have Improve Juniper JN0-103 dumps study guide. PASSED JN0-103 First attempt! Here What I Did.
Free demo questions for Juniper JN0-103 Exam Dumps Below:
NEW QUESTION 1
What is the minimum system-defined user class required to issue clear commands?
- A. read-only
- B. super-user
- C. operator
- D. authorized
Answer: C
NEW QUESTION 2
Which two conditions must exist in a Junos device for traffic to transit the device to a specific destination? Choose Two
- A. A forwarding table entry for that destination must exist
- B. A routing policy must be in place on the device
- C. A firewall filter must exist to allow traffic to reach that destination
- D. A routing table entry for that destination must exist
Answer: AD
NEW QUESTION 3
In which directory the traceoption files stored by default?
- A. /var/db/
- B. /var/tmp/
- C. /var/log/
- D. /var/home/
Answer: C
NEW QUESTION 4
You are in configuration mode at the top of the hierarchy. How would you save your configuration to a file on the router?
- A. save configuration <filename>
- B. save config <filename>
- C. save <filename>
- D. save run <filename>
Answer: C
NEW QUESTION 5
Exhibit:
Which statement is true about the command shown in the exhibit?
- A. There needs to be a ; after top for the command to be accepted as a valid command.
- B. Only top should be used, no other options are allowed on the same line.
- C. The command shown in the exhibit would be accepted as a valid command.
- D. If you replace top with up command, it becomes valid.
Answer: C
NEW QUESTION 6
Which keystrokes are used to auto-complete user-defined variables?
- A. Spacebar
- B. Home
- C. End
- D. Tab CC
Answer: D
NEW QUESTION 7
What configuration parameter on a Junos device modifies the default next-hop resolution behavior of a static route?
- A. Resolve
- B. No-readvertise
- C. Passive
- D. Preference
Answer: A
NEW QUESTION 8
You are troubleshooting an issue and want to monitor syslog in real time. Which operational command accomplishes this task?
- A. show log messages | refresh 1
- B. monitor traffic interface fxp0.0
- C. monitor start messages
- D. show log messages
Answer: C
NEW QUESTION 9
Referring to the exhibit,
***Exhibit is Missing***
which command will change the 172.16.10.1/24 IP address to 172.6.100.1/24 IP address?
- A. Set interfaces ge-0/0/2 unit 0 family inet address 172.16.100.1/24
- B. copy interfaces ge-0/0/2 unit 0 family inet address 172.16.10.1/24 to address 172.16.100.1/24
- C. rename interfaces ge-0/0/2 unit 0 family inet address 172.16.10.1/24 to address 172.16.100.1/24
- D. insert interfaces ge-0/0/2 unit 0 family inet address 172.16.10.1/24 before address 172.16.100.1/24
Answer: A
NEW QUESTION 10
Which two interfaces are considered logical interfaces? (Choose two.)
- A. xe-1/1/1
- B. ge-2/0/2.0
- C. et-5/0/0
- D. ae1.1
Answer: CD
NEW QUESTION 11
Which two interfaces are considered physical interface? Choose TWO
- A. Ge-0/0/0
- B. Et-3/0/0:0.501
- C. Et-7/1/4:0
- D. Xe-10/2/1
Answer: AD
NEW QUESTION 12
What statement is true about the orlonger route-filter match type?
- A. All routes within the specified prefix that are longer than the given prefix are considered a match
- B. All routes within the specified prefix that are longer or equal to the given prefix up to a defined acceptable prefix length are considered a match
- C. All routes within the specified prefix that are longer or equal to the given prefix are considered a match
- D. All routes within the specified prefix that are longer than the given prefix up to a defined acceptable prefix length are considered a match
Answer: A
NEW QUESTION 13
In which directory are trace option files stored by default?
- A. /var/tmp/
- B. /var/log/
- C. /var/home/
- D. /var/db/
Answer: B
NEW QUESTION 14
Which two platforms are supposed in both physical and virtual form factors? Choose TWO
- A. NFX Series
- B. ACX Series
- C. SRX Series
- D. MX Series
Answer: CD
NEW QUESTION 15
Refer to Exhibit:
Which parameter at the end of the command would provide information for troubleshooting pusposes?
- A. No-timestamp
- B. Extensive
- C. Print-ascii
- D. No-resolve
Answer: B
NEW QUESTION 16
How does the PFE determine how to forward transit traffic?
- A. The PFE performs a destination lookup based on its own routing table.
- B. The PFE determines network destinations itself based on the RE’s routing table.
- C. The PFE uses the following table provided by the RE.
- D. The PFE uses the routing table provided by the RE.
Answer: A
NEW QUESTION 17
Which two statements are true about static routes in the Junos OS (Choose Two)
- A. Static routes remain in the routing table until you remove them or until they become inactive
- B. Static routes are learned by neighboring devices and added to their routing tables
- C. Static routes are defined at the [edit routing-instance] hierarchy
- D. Static routes must have next hop defined
Answer: AD
NEW QUESTION 18
What is the maximum number of rollback files a Junos device can store?
- A. 5
- B. 10
- C. 49
- D. 50
Answer: D
NEW QUESTION 19
Which two statements are true about the default behavior of Junos routing policies? (Choose two.)
- A. Routing policies can export active and inactive routes.
- B. Routing policies can export only active routes.
- C. Routing policies control the flow of routing information going to and from the routing table.
- D. Routing policies control the flow of routing information going to and from the forwarding table.
Answer: BD
NEW QUESTION 20
......
P.S. Thedumpscentre.com now are offering 100% pass ensure JN0-103 dumps! All JN0-103 exam questions have been updated with correct answers: https://www.thedumpscentre.com/JN0-103-dumps/ (142 New Questions)