Testking offers free demo for JN0-104 exam. "Junos - Associate (JNCIA-Junos)", also known as JN0-104 exam, is a Juniper Certification. This set of posts, Passing the Juniper JN0-104 exam, will help you answer those questions. The JN0-104 Questions & Answers covers all the knowledge points of the real exam. 100% real Juniper JN0-104 exams and revised by experts!
Online JN0-104 free questions and answers of New Version:
NEW QUESTION 1
You are in configuration mode at the top of the hierarchy. How would you save your configuration
to a file on the router?
- A. save configuration <filename>
- B. save config <filename>
- C. save <filename>
- D. save run <filename>
Answer: C
NEW QUESTION 2
A BGP route does not match any term within a routing policy applied to BGP. Which action is taken by the router for this route?
- A. It discards the route by the implicit ‘discard all’ at the end of the policy.
- B. It advertises the route according to BGP rules.
- C. It discards the route by the default routing protocols policy.
- D. It discards the route because it is unable to match the route to a configured action.
Answer: B
NEW QUESTION 3
How does the PFE determine how to forward transit traffic?
- A. The PFE performs a destination lookup based on its own routing table.
- B. The PFE determines network destinations itself based on the RE’s routing table.
- C. The PFE uses the following table provided by the RE.
- D. The PFE uses the routing table provided by the RE.
Answer: C
NEW QUESTION 4
Which three benefits are made possible by the separation of the control plane and forwarding plane of a Junos device? (Choose three.)
- A. nonstop active routing
- B. in-service software upgrades
- C. deep packet inspection
- D. stateful firewall
- E. graceful Routing Engine switchover
Answer: ABE
NEW QUESTION 5
You are in configuration mode at the top of the hierarchy. You need to abort the changes that you have made and start again with a fresh copy of the active configuration. Which command should you use to accomplish this task?
- A. rollback 0
- B. load active
- C. reset config
- D. clear candidate config
Answer: A
NEW QUESTION 6
Which command is used to validate the syntax of a configuration without applying the
configuration?
- A. commit check
- B. commit confirmed
- C. commit synchronize
- D. commit and-quit
Answer: A
NEW QUESTION 7
You are asked to configure a Junos device to perform regular configuration backups
Which feature will you configure under the [edit system) hierarchy to accomplish this task?
- A. archival
- B. backup-router
- C. syslog
- D. tracing
Answer: B
NEW QUESTION 8
Exhibit:
Referring to the exhibit, which statement is true?
- A. Traps are allowed from 10.21.15.180
- B. Traps are sent to 10.21.15.180
- C. Traps are sent to 10.21.15.16
- D. Traps are allowed from 10.21.15.16
Answer: D
NEW QUESTION 9
What information is provided by the show route forwarding-table command?
- A. the routing table stored on the RE
- B. the protocol from where the route was learned
- C. the outgoing interface(s) associated with the destination prefixes
- D. the number of routes that are active, hidden, or in a hold-down state
Answer: C
NEW QUESTION 10
Click the Exhibit button
You are connecting to a new device in your network and are presented with the information and prompt shown in the exhibit
Which three steps must be carried out to edit the configuration on this device? (Choose three.)
- A. Type configure at the > prompt.
- B. Log in using the root user with no password.
- C. Type cli at the = prompt
- D. Type cli at the > prompt
- E. Log in using the root user with the root 123 password.
Answer: AB
NEW QUESTION 11
Click the Exhibit button.
***Exhibit is Missing***
Referring to the exhibit, how many received packets are classified as exception traffic?
- A. 20814681
- B. 14442602
- C. 12417
- D. 27824
Answer: B
NEW QUESTION 12
At which hierarchy would you configure a static MAC address for interface ge-0/0/0?
- A. [edit interfaces ge-0/0/0 unit 0]
- B. [edit interfaces ge-0/0/0]
- C. [edit interfaces ge-0/0/0 unit 0 family inet]
- D. [edit interfaces ge-0/0/0 unit 0 family inet address 172.25.11.2/24]
Answer: D
NEW QUESTION 13
Click the Exhibit button.
Referring to the exhibit, if the router forwards traffic destined for 192.168.77.29, which next hop will be used?
- A. 10.10.1.2
- B. 10.10.11.2
- C. 10.10.0.2
- D. 10.10.20.2
Answer: C
NEW QUESTION 14
Which two statements about login classes are correct? (Choose two.)
- A. Login class permissions can be overridden for certain commands.
- B. Users can be members of multiple login classes.
- C. Login classes define access privileges for a user.
- D. There are no system-defined login classes.
Answer: AC
NEW QUESTION 15
Which two interfaces are considered physical interfaces? (Choose two.)
- A. xe-10/2/1
- B. ge-0/0/0
- C. et-3/0/0/0:0.501
- D. et-7/1/4.0
Answer: AB
NEW QUESTION 16
Exhibit:
While working on a Junos Device, you receive the message shown. In this scenario, what would you do to stop the shutdown process?
- A. Issue the clear system commit command
- B. Issue the clear system reboot command
- C. Issue the request system halt in command
- D. Issue the request system power-off in command
Answer: B
NEW QUESTION 17
......
P.S. Easily pass JN0-104 Exam with 270 Q&As Certleader Dumps & pdf Version, Welcome to Download the Newest Certleader JN0-104 Dumps: https://www.certleader.com/JN0-104-dumps.html (270 New Questions)