It is impossible to pass Cisco 300 075 dump exam without any help in the short term. Come to Ucertify soon and find the most advanced, correct and guaranteed Cisco 300 075 pdf practice questions. You will get a surprising result by our Regenerate Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2) practice guides.
Q46. When you configure regions in a Cisco Unified Communications Manager multisite cluster, which two are ways to prevent G.722 from being advertised in the cluster? (Choose two.)
A. modify the service parameter
B. modify the enterprise parameter
C. modify the device pool
D. modify the line settings
Answer: A,B
Q47. The network administrator of Enterprise X receives reports that at peak hours, some calls between remote offices are not passing through. Investigation shows no connectivity problems. The network administrator wants to estimate the volume of calls being affected by this issue. Which two RTMT counters can give more information on this? (Choose two.)
A. CallsRingNoAnswer
B. OutOfResources
C. LocationOutOfResources
D. RequestsThrottled
E. CallsAttempted
Answer: B,C
Q48. Which option configures call preservation for H.323-based SRST mode?
A. voice service voip h323 call preserve
B. call preservation not possible with H.323
C. call-manager-fallback preserve-call
D. dial-peer voice 1 voip call preserve
Answer: A
Q49. Refer to the exhibit.
What is the correct value to use for the "DSCP for TelePresence Calls" Cisco CallManager service parameter?
A. 28 (011100)
B. 34 (100010)
C. 41 (101001)
D. 46 (101110)
Answer: A
Q50. Scenario
There are two call control systems in this item. The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 9971 Video IP Phone. The Cisco VCS is controlling the SX20, the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows.
Use the exhibits to answer the following questions.
SX20 System Information
DX650 Configuration
MRGL
DP
Locations
AARG
CSS
Movi Failure
Movi Settings
What two issues could be causing the Cisco Jabber Video for TelePresence failure shown in the exhibit? (Choose two.)
A. Incorrect username and password
B. Wrong SIP domain configured.
C. User is not associated with the device.
D. IP or DNS name resolution issue.
E. CSF Device is not registered.
F. IP Phone DN not associated with the user.
Answer: B,D
Q51. Scenario
There are two call control systems in this item. The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 7965 and 9971 Video IP Phones. The Cisco VCS and TMS control the Cisco TelePresence Conductor, the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows.
Use the exhibits to answer the following questions.
DNS Servers
Device Pool
Expressway
ILS
Locations
MRA
Speed Dial
SIP Trunk
What two tasks must be completed in order to support calls between the VCS controlled endpoints and the Cisco Unified CM endpoints? (Choose two.)
A. Media Resource Group List.
B. Configure a SIP trunk on the Cisco Unified CM to point to the Cisco VCS.
C. Configure a neighbor zone on the Cisco Unified CM to point to the Cisco VCS.
D. Configure a SIP trunk on the Cisco VCS to point to the Cisco Unified CM.
E. Configure a neighbor zone on the Cisco VCS to point to the Cisco Unified CM.
Answer: B,D
Q52. When you configure Cisco Unified Communications Manager, you need to configure the router for Survivable Remote Site Telephony in case the Cisco Unified Communications Manger stops working. On which two factors would the number of IP phones and Directory Numbers that can register to the SRST router depend? (Choose two.)
A. The protocol that is used in Cisco Unified Communications Manager
B. Cisco Unified Communications Manager version
C. Cisco IOS Software version
D. WAN link bandwidth
E. capacity of the Cisco Media Convergence Server
F. router platform
Answer: C,F
Q53. Which statement is true when device mobility mode is enabled or disabled in the Phone
Configuration window?
A. The device mobility mode phone settings take precedence over the service parameter settings.
B. The service parameter settings take precedence over the device mobility mode phone settings.
C. The combined service parameter settings and the device mobility mode phone settings will be used.
D. The default settings will be used due to the conflicts.
Answer: A
Q54. Company X has deployed a VCS Control with a local zone and a traversal client zone. To facilitate external calls, VCS Expressway is deployed and traversal server zone is set up there. Video endpoints inside Company X have registered but are unable to receive calls from outside endpoints. Which option could be the cause of this issue?
A. The access control list on the VCS Control must be updated with the IP for the external users.
B. When a traversal zone is set up on VCS Control only outbound calls are possible.
C. The local zone on the VCS Control does not have a search rule configured.
D. The traversal zone on the VCS Control does not have a search rule configured.
Answer: C
Q55. When implementing a dial plan for multisite deployments, what must be present for SRST to work successfully?
A. dial peers that address all sites in the multisite cluster
B. translation patterns that apply to the local PSTN for each gateway
C. incoming and outgoing COR lists
D. configuration of the gateway as an MGCP gateway
Answer: B
Q56. Which two locations are the best locations that an end user can use to determine if an IP phone is working in SRST mode? (Choose two.)
A. Cisco Unified Communications Manager Administration
B. IP phone display
C. Cisco Unified SRST Router
D. Cisco Unified MGCP Fallback Router
E. physical IP phone settings
Answer: B,E
Explanation:
Incorrect Answer: A, C, D IP Phone display and Physical phone IP settings are two locations were an end user can determine if an IP phone is working in SRST mode. Link: http://my.safaribooksonline.com/book/telephony/1587050757/survivable-remote-site-telephony-srst/529
Q57. Refer to the exhibit.
When the user of a phone registered to the Cisco Unified Communications Manager places a call to 3001 when the SAF network is down, what happens?
A. The call fails.
B. The call is rerouted to the PSTN with the constructed PSTN number as +442288223001
C. The call is rerouted to the PSTN with the constructed PSTN number as 442288223001
D. The call is rerouted to the PSTN with the constructed PSTN number as 0002288223001
E. The call is rerouted to the PSTN with the constructed PSTN number as +0002288223001
Answer: A
Explanation:
Incorrect Answer: B, C, D When the SAF forwarder loses network connection with its call-control entity, the SAF forwarder withdraws those learned patterns that were published by the call control entity. In this case, CCD requesting service marks those learned patterns as unreachable via IP, and the calls get routed through the PSTN gateway. Link:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmfeat/fscallcontrol discovery.html
Q58. Scenario
There are two call control systems in this item. The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 9971 Video IP Phone. The Cisco VCS and TMS control the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows.
Use the exhibits to answer the following questions.
DP
Locations
CSS
SRST
SRST-BR2 Config
BR2 Config
SRSTPSTNCall
Which device configuration option will allow an administrator to control bandwidth between calls placed between branches?
A. Media Resource Group List
B. Device Pool
C. Location
D. AAR Group
E. Regions
Answer: C
Explanation:
In Cisco Unified Communications Manager Administration, use the System > Location Info menu path to configure locations. Use locations to implement call admission control in a centralized call-processing system. Call admission control enables you to regulate audio quality and video availability by limiting the amount of bandwidth that is available for audio and video calls over links between the locations
Q59. Refer to the exhibit.
Which configuration change is needed to enable NANP international dialing during MGCP fallback?
A. Change the dial peer to dial-peer voice 901 voip.
B. Change the dial peer to dial-peer voice 9011 pots.
C. Add the command prefix 011 to the dial peer.
D. Add the command prefix 9011 to the dial peer.
Answer: C
Q60. Which remote-site redundancy technology fails over to POTS dial peers from the Cisco Unified Communications Manager dial plan during a WAN failure?
A. MGCP fallback
B. H.323 fallback
C. SCCP fallback
D. SIP fallback
Answer: A