Act now and download your Cisco 300-365 test today! Do not waste time for the worthless Cisco 300-365 tutorials. Download Improved Cisco Deploying Cisco Wireless Enterprise Networks exam with real questions and answers and begin to learn Cisco 300-365 with a classic professional.
Q31. A customer recently implemented WLC wireless multicast. Clients and connecting at the highest mandatory wireless rate of 24 Mbps and are receiving multicast traffic, but WLC cpu utilization and wired side network load has increased substantially. What three actions should the engineer take next to optimize the configuration? (Choose Three)
A. verify that Global Multicast mode has been enabled
B. verify that IGMP snooping is disabled on the wireless controller since the access points are handing IGMP messages from the clients.
C. make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth
D. verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows
E. change the wireless controller from Multicast-Unicastmodeto Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet
F. verify that the L3 interfaces are configured for pirn sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller’s management VLAN
Answer: A,B,E
Q32. You have just added a new MSE to Prime Infrastructure and want to synchronize the MSE with your 5508 WLC. which is located behind a firewall in a DMZ. You notice that NMSP messages are failing between the two devices. What traffic needs to be allowed on the Firewall to ensure the MSE and WLC can communicate using NMSP?
A. UDP 16113
B. TCP 1613
C. TCP 16113
D. UDP 1613
Answer: C
Q33. When a Vocera badge performs a broadcast call in a properly configured VoWLAN using WLC v7.0, which two choices indicate how the QoS is marked? (Choose two.)
A. Upstream marked as Best Effort.
B. Upstream marked as ToS CS4.
C. Upstream marked as DSCP EF.
D. Downstream marked as DSCP EF.
E. Downstream marked as Best Effort.
F. Downstream marked as Silver.
Answer: C,E
Q34. Which two options are limitations of using an AP as a workgroup bridge? (Choose two.)
A. Only factory-configured MAPs can support WGB mode.
B. MAPs that are configured in WGB mode do not answer S36 radio measurement requests.
C. A limited subset of Layer 2 security types are supported for wireless clients of a WGB.
D. There is a limit of 20 wired client devices.
E. Multiple VLANs are not supported for wireless clients.
Answer: B,D
Q35. A FlexConnect remote office deployment is using five 2702i APs indoors and two 1532i APs outdoors. When a code upgrade is performed and FlexConnect Smart AP Image Upgrade is leveraged, but no FlexConnect Master AP has been configured. How many image transfers between the WLC and APs will occur?
A. 7
B. 1
C. 5
D. 2
Answer: D
Q36. A network engineer must configure a 5 GHz network to allow for the greatest density of radios possible with the least amount of co-channel interference. Which configuration best fulfills this requirement?
A. Set 802.11 h Local Power constraint to 25 dBm.
B. Set DCA to 20 MHz channels and enable Extended UNII-2 channels.
C. Enable Event Driven RRM in 5 GHz with a sensitivity of High, n
D. Configure TPC Power Threshold to -80 dBm and set interference Optimal Mode (TPCv2).
Answer: B