we provide 100% Guarantee Cisco 300-365 practice question which are the best for clearing 300-365 test, and to get certified by Cisco Deploying Cisco Wireless Enterprise Networks. The 300-365 Questions & Answers covers all the knowledge points of the real 300-365 exam. Crack your Cisco 300-365 Exam with latest dumps, guaranteed!
Q1. A customer has implemented several WLANs in an auditorium utilizing a newly dedicated WLC and is experiencing excessive channel utilization regardless of occupancy. Which action reduces channel utilization without removing SSIDs?
A. Disable MCS data rates 0 through 11.
B. Disable MCS data rates used by 40 MHz channels.
C. Disable data rates that use CCK.
D. Disable VHT data rates.
Answer: C
Q2. A customer called into the support center with a problem ticket that involves wireless clients having to reauthenticate when they are walking around their office. After further investigation, it was discovered that the customer has two controllers in an N+1 deployment. Which action must the engineer take to troubleshoot the issue?
A. Verify that the wireless controllers are in the same mobility group and that the access points are all on the primary controller.
B. Under the SSID, make sure that 802.1 Iris configured and running for the clients.
C. Make sure that the SSID has the authentication set to 802.1x with Cisco Centralized Key Management so the data clients can roam seamlessly.
D. Verify the access points are spread out between the primary and secondary controller and that the controllers are in the same mobility group.
Answer: D
Q3. An engineer wants to configure WebEx to adjust the precedence and override the QoS profile on the WLAN. Which configuration is needed to complete this task?
A. Change the AVC application WebEx-app-sharing to mark
B. Create an ACL for WebEx.
C. Change the WLAN reserved bandwidth for WebEx.
D. Create an AVC profile for WebEx marked with a lower DSCP value
Answer: A
Q4. By default, how long does a Mobility Services Engine wait for an echo response from a Wireless LAN Controller before declaring the neighbor dead?
A. 10 Seconds
B. 60 Seconds
C. 15 Seconds
D. 30 Seconds
Answer: D
Q5. An engineer would like to capture NetFlowdata on PI. Which resource is required to allow this?
A. Cisco MSE as NetFlow exporter
B. Prime Infrastructure 1.0 or later
C. Cisco NAC as NetFlow exporter
D. Cisco ISE as NetFlow exporter
Answer: B
Q6. CORRECT TEXT
Scenario
One of your colleagues has setup a test network in the lab to simulate a new building atone of your regional offices. Your team is testing AP failover. Your colleague has requested you to configure the WLCs so that in the event of a loss of one of the WLCsthe other wings APs will fail over to the remaining WLC.
The APs on the East-WLC-2504A should fail over to the West-WLC2-2504A, and the APs on the West-WLC2-2504A should fail over to the East-WLC-2504A.
Set the priority of the APs so the backup controller recognizes the join request from the higher-priority AP and if necessary disassociates a lower-priority AP to provide access to an available port.
Not all menus, tabs and features are supported.
Topology
Answer:
Q7. A network engineer is debugging issues with the mDNS gateway. Which type of reply should be seen in the Wireshark capture when querying for a mDNS service in the Bonjour Cache?
A. unicast from Prime Infrastructure
B. unicast from controller
C. multicast from devices
D. multicast from controller
E. unicast from devices
F. multicast from Prime Infrastructure
Answer: B
Q8. Which network is connected by default when connecting to the unused Ethernet port of a MAP?
A. the native VLAN that the MAP is connected to
B. the VLAN that is associated with WLAN number 1 in the WLC
C. the native VLAN that the WLC is connected to
D. the VLAN that is associated with the SSID that the MAPs are communicating on
Answer: A
Q9. A corporation has a Cisco Unified Wireless Network that has been deployed for voice coverage. The wireless data rates have been tuned to mandatory rates of 18 Mbps and 36 Mbps. Some wireless clients have been experiencing drops streaming multicast video while moving throughout the building. What is the cause of the drop in video?
A. Clients are roaming at lower data rates and are not maintaining 36Mbps connectivity.
B. Clients are not roaming due to coverage. This is causing the multicast data to drop due to the client re-associating often.
C. Clients are connected at 18Mbps; however, other clients are connecting at 12Mbps and are causing the multicast video to degrade.
D. Clients are maintaining a 12Mbps rate and cannot receive the stream at 18Mbps.
Answer: A
Q10. An engineer used an interface group under the SSID configuration, but noticed that a test client is getting an IP assigned in a different VLAN from the DHCP server. Which two options override the interface group configuration on the SSID? (Choose two.)
A. static VLAN on client
B. ACL
C. AP group
D. static IP on client
E. MAC filtering
F. RF group
G. AAA override
Answer: C,G