Proper study guides for Latest Cisco Deploying Cisco Wireless Enterprise Networks certified begins with Cisco 300-365 preparation products which designed to deliver the Precise 300-365 questions by making you pass the 300-365 test at your first time. Try the free 300-365 demo right now.
Q21. You have a VoWLAN configured for platinum QoS, WMM, and CAC. IP phones for this VoWLAN include the Nokia and Cisco Unified Wireless IP Phones 7920G (pre-v2.0 firmware), 7921G, and 7925G. The Wireless IP Phones 7921G and 7925G work properly, but the Nokia and the Wireless IP Phones 7920G associate with the WLAN but cannot place calls. What is the issue?
A. The lowest mandatory speed in the WLAN is too high and needs to be reduced.
B. The Cisco Unified Wireless IP Phones 7920G and Nokia IP phones do not support TSPEC.
C. EDCA needs to be enabled on the WLAN.
D. HCCA needs to be enabled on the WLAN.
E. The reserved roaming bandwidth setting is set too low.
F. The expedited bandwidth setting needs to be enabled.
Answer: B
Q22. The customer has deployed C7960 phones with clients connected to them. What switch feature could be enabled to distinguish IP voice traffic from client data traffic?
A. VoiceVLAN
B. QoS routing
C. WME
D. Weighted Queuing
E. QBSS
Answer: A
Q23. A customer requires that an SSID is broadcasted to specific access points that use certain interfaces. Which feature can be used to achieve this goal?
A. mobility groups
B. flex-connect groups
C. interface groups
D. AP groups
Answer: C
Q24. You have set up FlexConnect APs. For which scenario is Fast Roaming supported, providing the WLAN is mapped to the same VLAN and the client is roaming to an AP on the same Cisco WLC?
A. central switching with PMK (OKC) between different FlexConnect groups
B. local switching with Cisco Centralized Key Management within the same FlexConnect group
C. central switching with Cisco Centralized Key Management between different FlexConnect groups
D. local switching with PMKID within the same FlexConnect group
Answer: B
Q25. VoWLAN implementation plans for a current mix of existing Cisco Unified Wireless IP Phones 7920G and 7921G to a final migration of Wireless IP Phones 7925G in a single WLAN. What would be the most appropriate WLC WLAN configuration to end with Wireless IP Phones 7925G?
A. 7920 Client CAC = enabled only; Radio Policy = All; WMM = Disabled
B. 7920 AP CAC = enabled only; Radio Policy = All; WMM = Allowed
C. 7920 Client CAC = enabled only; Radio Policy = 802.11a only; WMM = Disabled
D. 7920 AP CAC = enabled only; Radio Policy = 802.11a only; WMM = Allowed
E. 7920 Client CAC = enabled only; Radio Policy = 802.11b/g only; WMM = Disabled
F. 7920 AP CAC = enabled only; Radio Policy = 802.11b/g only; WMM = Allowed
Answer: B
Q26. A client reports that video is not streaming. The administrator determines the client is connecting at a data rate of 12 Mbps and is trying to stream to a valid multicast address on the network. What three items should the administrator check next to troubleshoot the issue? (Choose three)
A. IGMP snooping is turned off because the client cannot request to join a group, only access points can.
B. Video-stream for the multicast video is configured in the controller.
C. WLAN has been set for a QoS value of Platinum.
D. WLAN has been configured to allow multicast-direct to work correctly and multicast-direct has been enabled globally.
E. WLAN has been set for a QoS value of Gold.
F. RTSP is used to stream the video due to wireless multicast not using acknowledgements.
Answer: B,D,E
Q27. A wireless engineer at a convention center has been asked to provision an SSID that can accommodate 4,000 users during a conference. Which interface group configuration should be used?
A. One interface with /20 mask
B. Two interfaces with /21 mask
C. Four interfaces with /22 mask
D. Eight interfaces with /23 mask
Answer: D
Q28. Which of the following is not a Cisco RF fingerprinting key advantage over Location Tracking?
A. Uses existing LWAPP-enabled Cisco Unified Networking components.
B. Proprietary client hardware or software is required.
C. Better accuracy and precision.
D. Reduced calibration effort.
Answer: B
Q29. A wireless engineer wants to enable optimized roaming for their 5GHz wireless network with these settings: -72dBm RSSI value, 25% coverage exception level percentage, and a minimum of 50 packets received.
Which two commands achieve these settings? (Choose two.)
A. config advanced 802.11a coverage data fail-percentage 25
B. config advanced 802.11b optimized-roaming enable
C. config advanced 802.11b coverage data rssi-threshold -72
D. config advanced 802.11a optimized-roaming enable
E. config advanced 802.11a coverage data rssi-threshold -72
Answer: A,D
Q30. A network engineer has installed 802.11ac access points with 80 MHz enabled; however, in the conference rooms, co-channel interference is being noticed. Under which tab in the RF profiles configuration can the engineer find the settings to tune the channel width for a group of APs?
A. 802.11
B. RRM
C. High Density
D. General
Answer: B