Act now and download your Cisco 300-365 test today! Do not waste time for the worthless Cisco 300-365 tutorials. Download Up to the minute Cisco Deploying Cisco Wireless Enterprise Networks exam with real questions and answers and begin to learn Cisco 300-365 with a classic professional.
Q1. CMX Facebook WiFi can allow access to the network before authentication. Which two of the following options are available? (Choose two)
A. Allow all the traffic before authentication and intercept HTTPs only.
B. Allow HTTP traffic only before authentication and block all the traffic.
C. Allow SNMP traffic only before authentication and block all the traffic.
D. Allow all the traffic before authentication and intercept HTTP only.
E. Allow HTTPs traffic only before authentication and block all other traffic.
Answer: B,D
Q2. A customer requires that the remote site be able to utilize local servers when the AP is in WAN-down (standalone mode). Which AP mode must be configured on the wireless controller?
A. SE-Connect
B. Monitor
C. Local
D. FlexConnect
E. Sniffer
F. Rogue Detector
Answer: D
Q3. An engineer would like to capture NetFlowdata on PI. Which resource is required to allow this?
A. Cisco MSE as NetFlow exporter
B. Prime Infrastructure 1.0 or later
C. Cisco NAC as NetFlow exporter
D. Cisco ISE as NetFlow exporter
Answer: B
Q4. Which network is connected by default when connecting to the unused Ethernet port of a MAP?
A. the native VLAN that the MAP is connected to
B. the VLAN that is associated with WLAN number 1 in the WLC
C. the native VLAN that the WLC is connected to
D. the VLAN that is associated with the SSID that the MAPs are communicating on
Answer: A
Q5. What is the default NMSP echo interval between a Mobility Services Engine and Wireless LAN Controller?
A. 30Seconds
B. 15 Seconds
C. 10 Seconds
D. 60 Seconds
Answer: B
Q6. A network engineer has installed 802.11ac access points with 80 MHz enabled; however, in the conference rooms, co-channel interference is being noticed. Under which tab in the RF profiles configuration can the engineer find the settings to tune the channel width for a group of APs?
A. 802.11
B. RRM
C. High Density
D. General
Answer: B
Q7. A network engineer must configure a 5 GHz network to allow for the greatest density of radios possible with the least amount of co-channel interference. Which configuration best fulfills this requirement?
A. Set 802.11 h Local Power constraint to 25 dBm.
B. Set DCA to 20 MHz channels and enable Extended UNII-2 channels.
C. Enable Event Driven RRM in 5 GHz with a sensitivity of High, n
D. Configure TPC Power Threshold to -80 dBm and set interference Optimal Mode (TPCv2).
Answer: B
Q8. A network engineer is experiencing issues enabling LAG on the WLC. Which four characteristics should be validated to ensure LAG configuration? (Choose four.)
A. All ports participate in the LAG by default when LAG is enabled on the controller, y
B. Dynamic interfaces and management are moved to port 1
C. Primary and secondary ports are needed for each interface.
D. Multiple untagged interfaces to the same port are not allowed.
E. EtherChannel must be configured for mode "on" on the switch.
F. Only one functional physical port is needed to continue to pass traffic.
G. Multiple LAGs are permitted on the controller.
H. The WLC does not need to be rebooted to enable the LAG configuration.
Answer: A,D,E,F
Q9. After a wireless deployment, users report that wireless voice clients are experiencing an unacceptable amount of delay while roaming during a call on the Cisco Unified 7925 Series phones. The customer environment consists of multiple controllers, all running 7.4.121.0 code, operating in a centralized deployment. What configuration issue is most likely contributing to the problem?
A. The authentication should be set to WPA2-PSK to allow for 802.11n speeds for the Cisco Unified 7925 phones.
B. The access points on that floor are all on one controller and should be load balanced evenly across multiple controllers.
C. The access points for that floor are salt and peppered across multiple controllers and should be moved to the primary controller.
D. The wireless phones are operating in the 2 4 GHz band and should be configured for the 5 GHz band.
Answer: B
Q10. An engineer must deploy FlexConnect APs to a site that typically has 300 ms latency to the WLC. Which typical operating mode must the engineer plan on for normal operations?
A. local authentication, local switching
B. central authentication, central switching
C. central authentication, local switching
D. connected mode
Answer: A
Q11. You have set up FlexConnect APs. For which scenario is Fast Roaming supported, providing the WLAN is mapped to the same VLAN and the client is roaming to an AP on the same Cisco WLC?
A. central switching with PMK (OKC) between different FlexConnect groups
B. local switching with Cisco Centralized Key Management within the same FlexConnect group
C. central switching with Cisco Centralized Key Management between different FlexConnect groups
D. local switching with PMKID within the same FlexConnect group
Answer: B
Q12. A wireless engineer at a convention center has been asked to provision an SSID that can accommodate 4,000 users during a conference. Which interface group configuration should be used?
A. One interface with /20 mask
B. Two interfaces with /21 mask
C. Four interfaces with /22 mask
D. Eight interfaces with /23 mask
Answer: D
Q13. A customer is implementing a massively scaled guest wireless network to support approximately 32,000 clients. For ease of administration, they have required implementing multiple interfaces defined on the WLC and mapped to a single interface group. Which configuration meets this need?
A. 264 interfaces of/25 sized networks
B. 132 interfaces of/24 sized networks
C. 66 interfaces of/23 sized networks
D. 33 interfaces of /22 sized networks
Answer: D
Q14. A customer called into the support center with a problem ticket that involves wireless clients having to reauthenticate when they are walking around their office. After further investigation, it was discovered that the customer has two controllers in an N+1 deployment. Which action must the engineer take to troubleshoot the issue?
A. Verify that the wireless controllers are in the same mobility group and that the access points are all on the primary controller.
B. Under the SSID, make sure that 802.1 Iris configured and running for the clients.
C. Make sure that the SSID has the authentication set to 802.1x with Cisco Centralized Key Management so the data clients can roam seamlessly.
D. Verify the access points are spread out between the primary and secondary controller and that the controllers are in the same mobility group.
Answer: D
Q15. CORRECT TEXT
Scenario
One of your colleagues has setup a test network in the lab to simulate a new building atone of your regional offices. Your team is testing AP failover. Your colleague has requested you to configure the WLCs so that in the event of a loss of one of the WLCsthe other wings APs will fail over to the remaining WLC.
The APs on the East-WLC-2504A should fail over to the West-WLC2-2504A, and the APs on the West-WLC2-2504A should fail over to the East-WLC-2504A.
Set the priority of the APs so the backup controller recognizes the join request from the higher-priority AP and if necessary disassociates a lower-priority AP to provide access to an available port.
Not all menus, tabs and features are supported.
Topology
Answer:
Q16. A customer has implemented several WLANs in an auditorium utilizing a newly dedicated WLC and is experiencing excessive channel utilization regardless of occupancy. Which action reduces channel utilization without removing SSIDs?
A. Disable MCS data rates 0 through 11.
B. Disable MCS data rates used by 40 MHz channels.
C. Disable data rates that use CCK.
D. Disable VHT data rates.
Answer: C
Q17. A client reports that video is not streaming. The administrator determines the client is connecting at a data rate of 12 Mbps and is trying to stream to a valid multicast address on the network. What three items should the administrator check next to troubleshoot the issue? (Choose three)
A. IGMP snooping is turned off because the client cannot request to join a group, only access points can.
B. Video-stream for the multicast video is configured in the controller.
C. WLAN has been set for a QoS value of Platinum.
D. WLAN has been configured to allow multicast-direct to work correctly and multicast-direct has been enabled globally.
E. WLAN has been set for a QoS value of Gold.
F. RTSP is used to stream the video due to wireless multicast not using acknowledgements.
Answer: B,D,E
Q18. VoWLAN implementation plans for a current mix of existing Cisco Unified Wireless IP Phones 7920G and 7921G to a final migration of Wireless IP Phones 7925G in a single WLAN. What would be the most appropriate WLC WLAN configuration to end with Wireless IP Phones 7925G?
A. 7920 Client CAC = enabled only; Radio Policy = All; WMM = Disabled
B. 7920 AP CAC = enabled only; Radio Policy = All; WMM = Allowed
C. 7920 Client CAC = enabled only; Radio Policy = 802.11a only; WMM = Disabled
D. 7920 AP CAC = enabled only; Radio Policy = 802.11a only; WMM = Allowed
E. 7920 Client CAC = enabled only; Radio Policy = 802.11b/g only; WMM = Disabled
F. 7920 AP CAC = enabled only; Radio Policy = 802.11b/g only; WMM = Allowed
Answer: B